ShirTaI M800-Bi 320W Powerfull COB Light User Manual
- July 26, 2024
- ShirTaI
Table of Contents
ShirTaI M800-Bi 320W Powerfull COB Light User Manual
Remote control
About Light-effect Key
- Cyclic Mode: Click this key will create a color temperature cycle effect
- Flicker Mode: Each click of this key can switch the light effect
When in light effect: Click the “K” key on the remote control can adjust
the speed and “P” key can adjust the brightness.
If you need to close it, you can click any of these buttons (3000K, 4200K,
5500K)
Note
- Input voltage is AC 110V, 60Hz
- Due to the high power of the product, do not block the heat dissipation hole when using, and do not place the lamp on flammable materials to avoid fire
- Do not use in wet places such as bathrooms
- After use, please turn off switch on the back of the lamp and cut off the power supply.
Package List:
-
M800-BI COB Light ×1
-
Protective Cover x1
-
Standard Reflector ×1
-
Power Cord ×1
-
Remote Control ×1
-
Accessories Package x1
-
User Manual x1
-
Carrying Bag x1
Installation
-
Remove the protective cover before installation.
Pull back the lock button, turn counterclockwise to mounting point and remove cover. -
Loosen the knob (1), place it on the light stand, and lock the knob (PS: not include the light stand)
-
Loosen the two angle adjustment knobs at the same time. (Rotate according to the direction on the picture), adjust to the appropriate angle and lock them
-
Align the cover with the lamp mounting point, put on the cover, turn clockwise and lock it.
Tips: Other products with Bowers Mounting can also be installed to the lamp
Product Appearance:
Front
Back
Silent Mode : Click, the fan stops working, the brightness is 30%, click
again, the brightness is 50%. Click again, the fan returns to the working
mode, no longer silent.
Lighting Effects: There are 6 light effects, each click of the key, you
can switch the effect, while the dimmer knob can adjust the brightness. If you
want to turn off the effects, turn the color temperature knob.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected. -
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. The device has been evaluated to meet general RF exposure requirement. The device can be used importable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>