MINISO A113 Stereo Wireless Speaker User Manual
- July 26, 2024
- MINISO
Table of Contents
A113
User Manual
Unpack
Open the package and check whether the following parts are complete
-EW:A\Audio A113
-USB data cable
Key interface
Quick Start
on and off: Press and hold the switch button for about 2 seconds.
There is a tone for starting up and shutting down
Charging: Use a Micro USB port charger Charge the stereo.
Charging button inside the red light, power Fill and extinguish.
Bluetooth connection
Open the Bluetooth Settings screen, search for “EWA Audio A113” and connect to
Bluetooth.
T-card mode takes precedence over Bluetooth mode.
Interconnection
Interconnect pair (second one needs to be purchased separately)
- Bluetooth off
- Make sure you don’t have a microSD card inserted into your speaker
- Press and hold both to power on
- Double-click one of the two devices. When you hear the beep tone, the pair is successfully paired and the blue light turns on. If you do not succeed within 30 seconds, repeat steps 2 and 3.
- Turn on your Bluetooth Settings to search and pair, and the blue light will blink slowly after the pairing is successful
Note：
b. a. First interconnect 1 After pairing is complete, the two speakers will
automatically pair after turning on, and then also automatically connect to
your Bluetooth device without any further action.
b. If automatic pairing is not possible, try deleting your Bluetooth device
Record and repeat the above steps to complete the pairing.
Crash reset
When the speaker crashes and cannot be controlled, you can reset it.
Press the power button for 8 seconds to reset.
Indicator
| Red| Blue
---|---|---
Charging| long light| /
fully charged| /| /
standby| /| long light
playing| /| Slow flash
Search in Bluetooth| /| quick flash
Specification
- Battery :900mAh
- Power :5W
- Frequency response :100-18KHz
- SNR :S/N≥85Db Size: Diameter 48x56mm
- Playback time at appropriate volume :4 hours
- Battery charging time :2 hours
- Bluetooth transmission frequency range :2.4-2.48GHz
- Bluetooth communication protocols :HS/HF,A2DP,AVRCP,OPP
Note
- By default, the Bluetooth pairing state is entered when the device is turned on. After the device is turned on, the speaker will automatically search for and pair historical devices.
- Do not use this product in areas with water.
- Please wipe and clean this product with a dry cloth only.
- Open flame sources, such as lit candles, should not be placed around the unit.
- Pay attention to environmental protection when handling batteries.
- This product can only be used in mild climate environment.
- Do not step on or squeeze the power cord.
- Do not repair this product by yourself, this product does not contain any parts that can be repaired by the user.
Warranty card
Dear customer:
Hello! Thank you very much for using this product, we will provide you with
quality products and after-sales service System, fully protect your
consumption only rights and interests is our obligation. Therefore, our
company roots According to the relevant regulations of the State, the
following standard warranty service terms are implemented. According to
(mobile phone, etc Product repair, replacement and return liability
provisions), the use of the following products can enjoy warranty service; 3
batteries Speaker for 12 months, due to human damage and use of inferior
chargers resulting in danger and product damage, Our company will not bear the
corresponding responsibility, thank you for your cooperation, hope to pay
attention.
To purchase this product, please fill in this card carefully and keep it
properly.
Product serial number: 1
Date of purchase :
User name: one
Contact number: one
User address: one
Distributor 1
Responsible person :
Contact number one
Address :___
Signature I
certificate
Model: A113. Name:STEREO WIRELESS SPEAKE
Specification Ø48 « 56mm
Standard : GB8898-2011 GB4943.1-2011
This product has passed the inspection and is ready for delivery.
Inspector: Inspection 01
Factory Date:
Henan jiayinmei Electronics Co.,Ltd
info@ewacn.com
www.ewacn.com
+86-755-29918835
FCC Warning
15.19 Labeling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement:
- This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
- This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>