Harbor Mask Box Lamp Instruction Manual
- July 26, 2024
- HARBOR
Table of Contents
Harbor Mask Box Lamp Instruction Manual
Product accessories introduction
Feature:
After power-on, it is automatically turned on, Bluetooth mode is automatically
turned on, and the voice prompt tone is: waiting for connection, Bluetooth
name: BT Speaker. When the phone is turned on and connected to Bluetooth name
BT Speaker, the voice announcement prompt is: If the connection is successful,
the music can be played. Long press or single point can control the
temperature reduction, long press or single point can control the temperature
increase, the LCD display to display the internal temperature of the box,
wireless charging 15W, the mobile phone or other devices with wireless
charging function, flat back in the lightning symbol center position, you can
wireless charging.
Note:
Wireless charging can not have foreign bodies, the heating temperature is
maintained at about 45 degrees Celsius, the cooling temperature is maintained
at about 13 degrees Celsius, and the temperature difference between the mask
box and the room is about 15 degrees Celsius
Product wiring diagram
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.
The FCC certification of this device refers to RF exposure testing performed
in typical operating conditions, where a person is no closer than 20
centimeters from the device surface at all times, except for non repetitive
patterns with transient time intervals in the order of a second. Only in the
stated conditions, the device is shown to fully comply with the FCC RF
Exposure requirements of KDB 447498.
For BT
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>