Infinix X6853 NOTE 40 Smart Phone User Manual
- July 26, 2024
- Infinix
Table of Contents
NOTE 40
X6853 User Manual (V)
Exploded diagram specification
| 1 | TP+LCM | 2 | FRONT HOUSING GRAPHITE_FILM |
|---|---|---|---|
| 3 | GRAPHITE PLATE | 4 | MIDDLE HOUSING |
| 5 | FRONT CAMERA FRAME | 6 | FRONT CAMERA GROUNDING COPPER FOIL |
| 7 | 32M CAMERA | 8 | SHIELDING CASE COPPER FOIL |
| 9 | MAIN BOARD | 10 | 108M CAMERA GROUNDING COPPER FOIL |
| 11 | 108M CAMERA | 12 | 8W CAMERA |
| 13 | 8W CAMERA CONDUCTIVE_FABRIC | 14 | 2M CAMERA |
| 15 | 2M CAMERA RUBBER | 16 | RECEIVER |
| 17 | MAIN FPC | 18 | BATTERY |
| 19 | UP FRAME | 20 | FLASH LAMP FPC |
| 21 | STEEL | 22 | MAIN PCB HEAT FILM |
| 23 | UP FRAME HEAT FILM | 24 | NFC WIRELESS FPC |
| 25 | COAXIAL CABLE 1 | 26 | COAXIAL CABLE 2 |
| 27 | SCREW | 28 | BATTERY COVER |
| 29 | REAR CAMERA DECORATION | 30 | REAR CAMERA LENS |
| 31 | 108M CAMERA LENS | 32 | 2M CAMERA LENS |
| 33 | SIM CONNECTOR | 34 | SPK BOX FRAME |
| 35 | ANTENNA SUB ADHESIVE | 36 | ANTENNA SUB |
| 37 | COAXIAL CABLE MYLAR | 38 | USB RUBBER |
| 39 | SUB RUBBER | 40 | FINGERPRINT |
| --- | --- | --- | --- |
| 41 | MOTOR | 42 | FINGERPRINT FOAM |
| 43 | LCM RUBBER |
Know your phone
- Front camera
- Volume + button
- Volume – button
- Power button
- NFC & Wireless charging
SIM/SD card installation
- Power off your phone.
- Refer to the following picture for SIM/SD card installation.
Charging the phone
You can charge your phone with a charger or by connecting it to a computer
using a USB cable (comes with the phone).
Use Infinix chargers and cables only. Other chargers or cables may damage the
device. This will invalidate your phone warranty.
FCC Caution
Labelling requirements.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Information to user.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the device.
Information to the user.
Note: This device has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This device generates, uses and may radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this device does cause harmful interference to radio or
television reception (able to be determined by turning the device off and on),
the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver.
- Connect the device to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This mobile phone meets the government’s requirements for exposure to radio
waves. The guidelines are based on standards developed by independent
scientific organizations through periodic and thorough evaluation of
scientific studies. The standards include a substantial safety margin designed
to assure the safety of all persons regardless of age or health.
FCC RF Exposure Information and Statement. The SAR limit of USA (FCC) is 1.6
W/kg averaged over one gram of tissue. Device types:X6853(FCC ID: 2AIZN-
YYS-X6853) has also been tested against this SAR limit. The highest SAR value
reported under this standard during product certification for use at the ear
is 1.08 W/kg and when properly worn on the body is 0.67 W/kg.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 1.0 cm must be
maintained between the user’s body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device
should not contain any metallic components. Body-worn accessories that do not
meet these requirements may not comply with RF exposure requirements and
should be avoided. Use only the supplied or an approved antenna.
For DTS patents, see http://patents.dts.com. Manufactured under license from
DTS Licensing Limited. DTS, the Symbol, & DTS and the Symbol together are
registered trademarks or trademarks of DTS, Inc. in the United States and/or
other countries. © DTS, Inc. All Rights Reserved.
Operating System: Android™
Android is a trademark of Google LLC.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>