Midea NF20-18UR Fan Heater Owner’s Manual
- June 3, 2024
- Midea
Table of Contents
OWNER’S MANUAL
FAN HEATER
MODEL: NF20-18UR
Thisproductis onlysuitableforwel insulated spaces or occasional use.
LOSTECHGROUPS.R.L.
ViaPortogallo11/60, 35127Padova(Italy)
READ AND SAVE THESE INSTRUCTIONS
Attention: Pictures in the IM are for reference only.
SAFETY INSTRUCTION
- Waning: In orderto avoid overheating, do not coverthe heater.
- If the supply cord is damaged, it must be replaced by the manufacturer or its service agentor asimilarly qualified person in orderto avoid a hazard.
- This appliancec,an be used by children aged from 8 years and alcove andpersonswith reducedphysical. sensory or rnentalca pa bilities or lack of experienceand knowledge if they have been given supervision or instruction concerning useof the appliancein asafe wayand understand the hazards involved. Children shal not play with the appliance. Cleaning and user maintenance shal not be made by children without supervision.
- The heater must not be located immediately belowa socket-oullet
- Do not use this heater in the immediatesurroundings of a bath, a sharer or a swirrrring pool.
- Children of less than 3 years should be kept away unless continuously supervised. Children aged from 3 years and less than 8 years shal only switch on/off the appliance provided that it has been placed or instated in its intended normal operating position and they have been given supervi-sion or instruction concerninguseof the appliance in asafe wayand understand the hazards involved. Children aged from 3 years and less than 8 years shal not plug in, regulateand cleanthe appliance or perform user mantenare.
- CAUTION – Some parts of this product can become very hot and cause burns. Particular atten-tion has to be given where children and vulnerable people are present.
- Correct Dispcsal of this product This markingindicatesthat this productshouldnot be disposed with otherhaisehold wastesthroughoutthe EU. To prevent possibleharm to the envircx anent cc hum’ health from unconttol ed waste disposal. recycle it resoonsiblyto promotethe sustainable reused material resources. Toretum youruseddevice, please usethe return andcolec-tion systems or contactthe retailer wherethe productwas puchased. They can take this product for environmental safe recycing.
- Do not use out of the house.
- Do not use this heater if it has been dropped.
- Do not use if there are visible signs of damageto the heater.
- Use this heateron a horizontal and stable surface, or fix it to the wall, as applicable.
- WARNING: Donot use this heater in smalroomswhenthey are occupied by persons not capable of leaving the room ontheir own, unless constant supervision is provided.
- WARNING: To reducethe risk of fire, keeptextiles, curtains, or any other flammable material a minimum distance of 1 mfrom the air outlet.
OPERATING INSTRUCTIONS
- Check if the power wire is under good condition.
- The product adopts 220-240V 50Hz AC power supply, before use, please confirm if the rated current of the power socket meets the local requirements with safe grounding device. otherwise, please replace it with the qualified socket.
• Put the machine on the flat place Uneven place may possibly cause the turnover switch at abnormal position, then the heater can’t work after turning on, therefore, please put the heater on the flat place, at least the surfacf below the base of the heater must be flat.
• Mode setting
press and hold ‘ -key to select between 4 functions: Fan apjyadligt, Heat, 1200W(LOW). Heat 2000W(HIGH).
• Temperature setting press and hold ‘ key to set the Temperature: 18°C. 21°C 24°C . 27°C 30°C.
• Turn off the Heater
A. Press’ ON/OFF” key to turn off the Heater .
B. Remove the power plug, store the heater after the entire machine has become cool.
• Safety Protection
1.0verheat protection: When the temperature in the heater is too high due to abnormality in the use environment or improper use, the thermostat device can automatically cut off the power and the heater stops working. After the whole heater is cooling, the heater can return to the normal use after removing the abnormality. 2. Inversion protection: When the whole heater is inverted, the safety system will automatically cut off the power, and return to the work state before inversion after the body is placed upright.
ADDITIONAL FEATURES
This heater has additional features:
• Convenient Carry Handle – allows for easy transport from room to room.
TROUBLESHOOTING
If your heater fails to operate, please follow these instructions:
- Ensure that your circuit breaker or fuse is working properly.
- Be sure the heater is plugged in and that the electrical outlet is working properly.
- If the machine suddently stops during heating. the temperature may be exceeds the threshold of the thermal cut-off. Turn it off. Then Make sure that there is no obstruction and cool the machine. Turn it on again by referring to the OPERATING INSTRUCTIONS.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE SEE THE WARRANTY INFORMATION FOR INSTRUCTIONS. PHASE DO NOT ATTEMPT TO OPEN OR REPAIR TIE NEATER YOURSELF. DOING SO MAY VOID TIE WARRANTY AND COULD CAUSE DAMAGE OR PERSONAL INJURY. IF THE PROBLEM STILL PERSISTS, PLEASE CONTACT OS BY REFERRING TO THE SERVICE a SUPPORT INFORMATION ON THE FOLLOWING PAGE
CLEANING AND STORAGE
It is recommended that the heater be cleaned at least one time during the operating season in order to provide the optimum level of performance. ALWAYS TURN TIE PIWER SWITCI OFF AND UNPLUG TIE NEATER REFINE CLEANING. Be sure to save the box for off-season storage.
- Turn off the heater unplug it and wait for the heater to cool down.
- Use a dry cloth to clean only external surfaces of the heater.
- Do not use any cleaning agents or detergents.
- Never immerse the heater in water.
- Pack the heater in the original carton and store it in a cool and dry place.
SPECIFICATIONS
Model No.: NF20-18UR
Voltage: 220-240V, 50Hz
Curent: Maximum continuous draw: 8.7 Amps.
Power: LO =1200 Watts, HI = 2000 Watts
Tolerances on all specifications: Not exceeded than 105%.
| Table for information requirements for electric local space heaters | P |
|---|
Model identifier(s): NF20-180R
Item| Symbo I| Value| Unit| Item| Unit
Heat output| Type of heat input, for electric local space heaters only (select
one)
Nominal heat output| Pnom| 2,0| kW| Manual heat charge control with integrated
thermostat| [no]
Minimum heat output (indicative)| Pmin| 1,2| kW| Manual heat charge control
with room and/or outdoor temperature feedback| [no]
Maximum
continuous heat output| Pmax| 2,0| kW| Electronic heat charge control with
room and/or outdoor temperature feedback| [no]
Auxiliary electricity consumption| Fan assisted heat output| [no]
At nominal heat output| elmax| 1,919| kW| Type of heat output/room temperature
control (select one)
At minimum heat output| elmin| 1,156| kW| Single stage heat output and no room
temperature control| [no]
In standby mode| elSB| 298| W| Two or more manual stages, no room temperature
control| [no]
| | | | With mechanic thermostat room temperature control| [no]
| | | | With electronic room temperature control| [yes]
| | | | Electronic room temperature control plus day timer| [no]
| | | | Electronic room temperature control plus week timer| [no]
| | | | Other control options (multiple selections possible)
| | | | Room temperature control, with presence detection| [no]
| | | | Room temperature control, with open window detection| [no]
| | | | With distance control option| [no]
| | | | With adaptive start control| [no]
| | | | With working time limitation| [no]
| | | | With black bulb sensor| [no]
Contact details:| Produced by: Guangdong Midea Environment Appliances
Manufacturing Company limited, address:
No.28 Dongfu Road. Ilesui East IndustrialArea. Dongfeng Town. Zhongshan.
Guangdong 528425 China
Remark:
For electric local space heaters, the measured seasonal space heating energy
efficiency cannot be worse than the declared value at the nominal heat output
of the unit.
The seasonal space heating energy efficiency of all local space heaters except
commercial local space heaters. IF(%)| 38
Midea offers the owner of this product a ONE YEAR WARRANTY, from the date of purchase, against all manufacturing defects in material and workmanship. The warranty card to be presented to authorized service centers / distributors along with the purchase invoice to claim the warranty. The warranty does not cover:
- Damage due to mishandling or fire and becomes invalid if repair has been attempted by unauthorized persons.
- Any failure to follow the instructions as mentioned in the user manual.
- Fluctuation in voltage or any modifications/adjustments made to comply with local electrical, safety and technical standards.
- Damages caused by fire, accident or any natural disaster, damage due to mishandling, wear & tear, voltage fluctuations.