TAC BA402299BP 5 Inch Oval Bent End Sidebar Installation Guide
- July 25, 2024
- TAC
Table of Contents
TAC BA402299BP 5 Inch Oval Bent End Sidebar Installation Guide
PARTS LIST:
| 1 | Driver/left Sidebar | 16 | 8-1.25mm x 30mm Hex Bolts |
|---|---|---|---|
| 1 | Passenger/right Sidebar | 16 | 8-1.25mm x 25mm Combo Bolts |
| 8 | Mounting Brackets | 16 | 8mm Lock Washers |
| 16 | 8mm x 24mm x 2mm Flat Washers |
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS
RECOMMENDED.
- Start the installation under the driver side of the vehicle. Locate the 6 plugs along the bottom edge of the body. Mounting Brackets will bolt to the 1st, 3rd, 4th and 6th threaded mounting holes, (Figures 1—5
Remove the plastic plugs from each mounting location. Directly above each threaded insert is a top mounting location on the side of the body panel. Hold a Bracket up in place to help determine the mounting holes to use along the body. NOTE: Thread an 8mm Hex Bolt into the threaded inserts to clear paint as required.
- Select (1) Mounting Bracket. Starting at the front of the driver/left side, bolt the Mounting Bracket to the factory threaded holes with (2) 8mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, **(Figures 6 & 7)
** Do not tighten hardware at this time.
- Repeat Steps 1 & 2 to install (3) Mounting Brackets on the remaining driver/left side mounting locations along the body panel, **(Figures 8—10).
**
- Select the Driver/left Sidebar. Use the illustration above to help determine the correct Sidebar. Place the Sidebar on top of the Brackets. IMPORTANT: Do not slide, (front to back or rotate), the Sidebar on the Brackets or damage to the finish may result.
- Attach the Sidebar to the Brackets with (8) 8mm Combo Bolts, **(Figures 11—15).
**
- Level and adjust the Sidebar and fully tighten all hardware.
- Repeat Steps 1—6 to install the Passenger/right Sidebar.
- Do periodic inspections to the installation to make sure that all hardware is secure and tight
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be used also to clean the Sidebars.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>