MATRIX AUDIO P2 Power Amplifier User Manual

MATRIX AUDIO P2 Power Amplifier

Packing list

Parts and names

Front

1. Power on/Standby
   • After connecting to the power supply, press this button to power the unit, and press it again to let the unit stand.
2. LED indicator
   • The LED indicator will go off when the unit is on standby. It flashes when the device is delayed starting, and will keep lit up after the device is started.

Rear

1. Mono mode input
   • In mono mode, a single amplifier drives 1 speaker. Connect the amplifier to 1 channel of the front-end audio source device through an XLR cable.
2. Stereo mode input
   • In stereo mode, a single amplifier drives 2 speakers. Both RCA and XLR cables can be used to connect to the left and right channels of the front-end audio source device.
3. Mode/input switch
   • Working mode and input method can be set by this switch. There are 2 input methods, XLR and RCA, that are available for Stereo mode. In Mono mode, only XLR input takes effect.
   • To avoid misoperation, toggling this switch when the unit is on will not change the current working mode immediately. The switch will take effect after the unit enters standby and starts again.
4. Speaker output
   • Please refer to the diagram below for speaker connection in Stereo mode.
   • Please refer to the diagram below for speaker connection in Mono mode.
   • Make sure to connect to speakers correctly to avoid damage to the devices.
5. USB Type-C
   • For firmware updates.
6. Trigger input/output
   • Connect to audio devices with trigger ports through 83.5 mm mono plug cables, to achieve a linkage control between the amplifier and other devices. The trigger output provides a 12V DC signal.
7. AC input
   • This unit adapts to AC100-120V and AC220-240V power voltage range automatically. Please make sure to use the product in the power voltage range mentioned above.
   • Please use the power cable which includes an earth wire. Please ensure you have a reliable earth wire connection. Otherwise, the casing of the unit may have a slightly charged touch. If you need the unit to be turned off completely, please unplug the power cable.

Technical specifications

Stereo mode RCA input

• Input impedance: 47k0
• Gain: 28dB@1kHz

Stereo mode RCA input

• Input impedance: 47kg
• Gain: 34dB@1kHz

Mono mode XLR input

• Input impedance: 47k0
• Gain: 28dB@1kHz

Speaker output

1. Stereo mode
   • Output power: 2 x 230W @ 1% THD+N, 20Hz – 20kHz, 40 2 x 110W @ 1% THD+N, 20Hz – 20kHz, 80
   • DNR: 112dB A-weighting
   • Frequency Response: 20Hz-20kHz $0.3dB
   • THD+ N: 0.008% @ 1W
   • Output impedance: <25m9
2. Mono mode
   • Output power : 850W @ 1% THD+N, 20Hz – 20kHz, 40 500W @ 1% THD+N, 20Hz – 20kHz, 80
   • DNR: 121dB A-weighting
   • Frequency Response: 20Hz-20kHz $0.3dB
   • THD+N: 0.004% @1W
   • Output impedance: <30m0

Trigger

• Trigger in: DC 6-12V <10mA

Power

• Trigger out: DC 12V/50mA MAX
• Power Voltage: AC 100V-120V 50/60Hz / AC 220V-240V 50/60Hz
• Standby   Power Consumption: < 5W
• Maximum   Power Consumption: 1200W

Other specifications

• Weight : 3.7kg (8.16 pounds)
• Size: Width 340mm(13.39 inches)
• Depth 259mm(10.20 inches)
• Height 58mm(2.28 inches)

Specifications are subject to change without notice.

ATTENTION

• This product is for indoor use only.
• For full ventilation, it is recommended to reserve a space larger than 5 cm around the device.
• Do not cover the air vents with stuff such as papers, tablecloths, and curtains to obstruct ventilation.
• Do not place stuff with flame, such as lighted candles, on the device.
• If the device is used in tropical areas, please be careful to prevent insects from entering the unit through the air vents.
• The device must not be subject to water droplets or splashes. Please do not place stuff filled with liquids such as vases and cups on or near the device.
• Do not put stuff around the device power plug and the AC power socket, to disconnect the power supply easily when needed.

HIGH-PERFORMANCE AUDIO

• www.matrix-digi.com.
• Matrix Electronic Technology Co., LTD
• +86-29-86211122
• Room 206 Block B, #58 Mingguang Rd,
• Xian, China

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>