9200 Additional Light Purelux Heat Instruction Manual
- July 23, 2024
- PURELUX
Table of Contents
9200 Additional Light Purelux Hea
INSTALLATION INSTRUCTIONS
Caution
Read all the instructions provided before installation// Disconnect the ground
connection from the battery to avoid accidental short circuits before
connecting electrical wires// Only operate under the specified voltages (DC
9-36V) // Do not touch the lamp or the casing for at least 30 minutes after
turning the light off to avoid heat injury. Keep the heat-sink clean and
exposed to maintain air flow// Do not stare directly into the light to avoid
eye injury// Use only soap and water for cleaning. Do not use pressure washer
for cleaning// Dispose the unit through your local recycling authorities//
THE DEFAULT CONNECTION OF THE LIGHT IS INTENTED FOR OFF-ROAD USE ONLY! REFER
TO THE WIRING-SECTION FOR MORE INFORMATION.
Wiring
- Ensure that the working voltage is correct and choose the corresponding relays (DC12V/24V)
- Connect the unit using a Purelux-wiring harness (sold separately)
- Remove any protective films from the lamp before operating
- Switch the power modes by pressing the button on the back of the lamp (OFF-ROAD/ ECE R149)
Wire description (Connected to power)
- White: Position light (White)
- Yellow: Position light (Amber)
- DTP2-Plug: Driving light connection
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>