PURELUX 4080130035 LED Work Light Installation Guide
- June 6, 2024
- PURELUX
Table of Contents
LED WORK LIGHT
INSTALLATION INSTRUCTIONS
Caution
- Read all the instructions provided before installation
- Disconnect the ground connection from the battery to avoid accidental short circuits before connecting electrical wires. If mounting requires drilling holes, make sure to avoid damaging any components of the vehicle
- Only operate under the specified voltages (DC10-30V)
- Do not touch the lamp or the casing for at least 30 minutes after turning the light off to avoid head injury. Keep the heat-sink clean and exposed to maintain airflow
- Do not stare directly into the light to avoid eye injury
- Use only soap and water for cleaning. Do not use a pressure washer for cleaning
Wiring
- Ensure that the working voltage is correct and choose the corresponding relays (DC12V/24V)
- Connect the light to the power source using a DT-2 connector. If DT-2 connection is not available, connect the red wire (RED+) to positive + and the black wire (BLK-) to negative –, on battery or ground
- Remove any protective films from the lamp before operating
- Turn on the light to test the connection. If the light is not working as expected, please refer to the instructions.
HANDSHAKE FINLAND OY www.handshake.fi
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>