Weofly Conquer Smartwatch User Manual
- July 23, 2024
- WEOFLY
Table of Contents
Weofly Conquer Smartwatch
Basic introduction to the product
Basic Product Operation
- Keep Pressing the power on/off button for 3 seconds to turn on or turn off your watch.
- You can switch different interfaces by swiping the touch screen of the smartwatch.
APP download, installation and use
Before pairing a watch with a smartphone, please ensure that your smartphone and watch are prepared as follows:
- When using the watch for the first time, it is recommended to charge it for at least 2 hours to ensure that the watch is fully charged
- Please ensure that your smartphone is adjacent to your watch
- Please ensure that the Bluetooth function of your smartphone is turned on Scan the following QR code to download and install the “Weofly Fit” App Device Requirement: iOS 10.0 and above, Android 6.0 and above, supports Bluetooth 5.0.
Note: The watch name and MAC address can be queried in the watch settings.
If you did not click to allow the watch to receive incoming call reminders and message notifications when pairing the app. If you want to receive notifications in the future, you will need to unbind your device and pair your watch again. After pairing is completed, please open the “Devices” page of the APP, click on “APP”, and select the APP you want to receive messages from.
Basic product functions
Other functions
Do not disturb mode/ Stopwatch/Countdown/Flashlight/Calculator/Alarm clock
reminder/Long sitting reminder/Find phone/Goal achievement reminder etc.
Disclaimer
This product is not an electrocardiogram or professional medical device, and
any of the above functions cannot be used as any medical data reference.
Attention
- Keep the product clean and dry
- Please wear the product correctly
- Do not place equipment and its accessories in areas with high or low temperatures, as this may cause equipment malfunction, fire, or explosion.
- Avoid strong impacts or vibrations on the product to prevent damage to the equipment and its accessories, leading to equipment failure.
- Do not disassemble or modify equipment and accessories without authorization. In case of equipment failure, please contact after-sales service.
- The waterproof performance of this product is not permanently effective and may weaken over time. Supports short-term use such as hand washing and rain, but does not support scenarios such as hot showers, diving, diving, and surfing. Watches do not have waterproof properties against corrosive liquids such as seawater, acidic and alkaline solutions, and chemical reagents.
- If the device is not used for a long time, please make sure to recharge it every three months.
Warning:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
Manufacturer: Shenzhen Weofly Innovation Technology CO., LTD
- Add: Factory Building 601-11, Nankeng 2rd Industrial Park, Bantian Street, Longgang District, Shenzhen City, Guangdong Province, China
- Website: www.weofly.com
- After-sales E-mail Address : service@weofly.com