INTERIORS NZS 3500 Inwall Mixer Body and Spout Pipe Installation Guide
- July 20, 2024
- INTERIORS
Table of Contents
INTERIORS NZS 3500 Inwall Mixer Body and Spout Pipe
Specifications
- Size: Inwall Mixer Body with 15mm pipe
- Inlet Size: 15mm
- Outlet Size: Half inch
- Cleaning Instructions: Clean with mild liquid detergent or soap and water
- Avoid: Cream cleaners, bleach, and abrasive cleaning pads
Product Information
- Ensure correct set-outs for installation.
- Attach the Inwall Mixer Body to the wall with the 15mm pipe exiting the top of the valve.
- Direct the pipe to the spout location using 90-degree elbows or suitable fittings based on the required spout location.
- Use appropriate thread sealant to secure connections.
- Mount the half-inch elbow back plate with the 15mm inlet orientated to the top.
- Test and commission the installation to ensure there are no leaks.
Product Usage Instructions
- Regularly clean the product with mild liquid detergent or soap and water to maintain its appearance.
- Avoid using cream cleaners or bleach as these substances are abrasive and may damage the material.
- Do not use cleaning pads with abrasive surfaces as they can scratch the material.
FAQ
- Q: Can I use abrasive cleaners on this product?
- A: No, it is recommended to avoid abrasive cleaners such as cream cleaners or bleach as they can damage the material. Use mild liquid detergent or soap for cleaning.
INSTALLATION GUIDE
Note: This product must be installed by a licensed plumber. This is a general installation guide – there are many factors involved that can alter the installation method.
AU/NZ
- For installations within Australia and New Zealand, this product must be installed in compliance with AS/NZS 3500.
UK
- For installations in the United Kingdom, this product must be installed in compliance with the Water Supply (Water Fittings) Regulations and Water Supply (Water Fittings) (Scotland) Byelaws.
Other
- For installations outside these countries, this product must be installed in compliance with the standards in your respective country.
Inwall Mixer Body and Spout Pipe Installation
Test and commission. Ensure no leaks
- Regularly clean with mild liquid detergent or soap and water
- DO NOT use cream cleaners or bleach.These substances are abrasive
- DO NOT use cleaning pads with abrasive surfaces as this may scratch the material
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>