HAVIT COMMERCIAL HCP-91301 3w Recessed LED Spitfire Emergency Light Instruction Manual
- July 20, 2024
- HAVIT COMMERCIAL
Table of Contents
HAVIT COMMERCIAL HCP-91301 3w Recessed LED Spitfire Emergency Light
Product Information
- Cut a suitable round hole in the ceiling.
- Connect the driver and luminaire. The power needs to be connected from inside the ceiling cavity before the luminaire can be installed.
- Push the spring clips upwards and install the luminaire in the ceiling.
- Note: For the first usage, power ON the unit for 24 hours to fully charge the battery. Interrupting the mains supply will discharge the battery.
- The emergency lamp must illuminate for at least 90 minutes after disconnection from the mains.
- Press and hold the Test Button or switch Off the Mains Supply, and check the emergency lamp is ON.
- Release the Test Button or Switch On the Mains Supply, and check the normal lamp is OFF (NON-Maintained operation).
Every month, the unit will discharge itself for 30 seconds. If the main power supply does not switch off for 12 months, the unit will discharge itself until out of battery, then will charge again.
FAQ
- Q: Can I install this product myself?
- A: No, it is illegal for anyone except a licensed electrician to install or maintain this product.
- Q: How long should I keep the unit powered on for the first usage?
- A: Power ON the unit for 24 hours to fully charge the battery before installation.
- Q: What should I do if the emergency lamp does not illuminate during testing?
- A: Contact a licensed electrician for further assistance and do not attempt to repair it yourself.
Important
It is illegal for anyone, except for a licensed electrician to install or
maintain this product. Before installation, ensure that the electricity supply
has been switched off and isolated. Installation must be carried out under the
relevant Australian and International Standards.
Specification
- Operating Supply: 220-240V / 50-60Hz
- Cut-out: 70mm, 135mm (with adaptor plate)
- Compliance: AS 2293
- Mounting: Recessed
- Classification D40
Installation
-
Cut a suitable round hole
-
Connect the driver and luminaire.
The power needs to be connected from inside the ceiling cavity before the luminaire can be installed. -
Push the spring clips upwards and install a luminaire in the ceiling.
Note
For first usage, power the unit for 24 hours to fully charge the battery.
Interrupting the mains supply will discharge the battery.
Testing
- The emergency lamp must illuminate for at least 90 minutes after disconnection from the mains.
- Press and hold Test Button or switch Off the Mains Supply, and check the emergency lamp is ON.
- Release the Test Button or Switch On Mains Supply, and check the normal lamp is OFF (NON-Maintained operation).
Self-Testing
- Every month, the unit will discharge itself for 30s.
- If the main power supply does not switch off for 12 months, the unit will discharge itself until out of battery, then will charge again.
Warranty
- Products have 3 year (from the date of purchase) replacement warranty including battery.
- Products have to be connected to permanent live power otherwise warranty will be void.
- Must be installed by a licensed electrician.
- This warranty does not cover loss or damage by misuse, incorrect installation, incorrect voltage or unauthorized electrical connections, or adverse external conditions (such as power surges and dips, exposure to heat, corrosion, etc).
- Products that have been altered in any way or used other than under instruction are not covered by this warranty.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>