Superlux LLED105 12 Volt LED Lindon Garden Light IP65 Instruction Manual
- June 3, 2024
- Superlux
Table of Contents
Installation Instructions
Models: LLED105
12 Volt LED Lindon Garden Light IP65
LLED105 12 Volt LED Lindon Garden Light IP65
It is recommended that this unit is installed by a registered electrician.
Isolate the electrical supply Use a constant voltage, 12 Volt DC Driver.
Choose a driver with a wattage that exceeds the total wattage of all fixtures
used in aggregate on your circuit. Ensure that the extra low voltage
connections are watertight so that the fixture cables do not siphon water.
DO NOT install in hollows where water will pool around the lighting fixture as
this may cause condensation and corrosion.
Only use LLED1 Drivers which have the appropriate cable connectors. The driver
supply cord must be plugged into a waterproof socket if in a wet area.
Locate driver in a ventilated location.
Do not overload the Driver. Do not cover the Driver. Isolate the Driver while
connecting lights to each other.
Only turn the power ON once all connections are completed otherwise LED lights
may be damaged.
Cables between driver and lights and between lights should not exceed 3 metres
long. For long length systems use a larger driver to avoid voltage drop
issues. When pushing connectors together, first check the orientation of the
Key and Slot to ensure correct alignment of polarity. Then twist cap onto
thread to secure and ensure watertightness. Fit plastic cap onto any unused
output cable.
POSSIBLE WIRING CONFIGURATIONS FOR A SINGLE CABLE SYSTEM
IN-LINE SYSTEM
The IN-LINE SYSTEM is the conventional way of connecting the light fittings
together but can be restrictive in the length of cable that is used due to the
effects of voltage drop on the light fitting furthest away from the driver.
TEE-LINE SYSTEM
The TEE-LINE SYSTEM is a method employed to counteract the effects of voltage
drop. By connecting the driver in the middle of the circuit you are able to
increase the length of the cable run and minimise the effects of voltage drop
on the end light fittings. 
Accessories available:
Extension cables LLED1-C1000 or LLED1-C2000, T connector LLED1-TEE and power
supply drivers LLED1-IPEC20 or LLED1-IPEC45
PLEASE NOTE: There are no user serviceable parts the LED is integral. Please
Keep instructions.
LLED105 Instructions A4.indd
28/06/22 1:59 PM
Documents / Resources
|
Superlux LLED105 12 Volt LED Lindon Garden Light
IP65
[pdf] Instruction Manual
LLED105 12 Volt LED Lindon Garden Light IP65, LLED105, 12 Volt LED Lindon
Garden Light IP65, LED Lindon Garden Light IP65, Lindon Garden Light IP65,
Garden Light IP65, Light IP65
---|---