KOHLER K-24009-GH Bubble Massage Bath Owner’s Manual

July 12, 2024
Kohler

KOHLER K-24009-GH Bubble Massage Bath

Specifications

  • Material: Not specified
  • Technology: BubbleMassageTM
  • Electrical Requirements:
    • Blower: 120 V, 15 A, 60 Hz
    • Heater: 120 V, 15 A, 60 Hz
  • Water Capacity: 60 gal (227.1 L)
  • Weight: 170 lbs (77.1 kg)
  • Water Depth: 16″ (406 mm)
  • Drain Location: Center
  • Basin Area, Bottom: 39-5/8″ x 23-5/8″ (1006 mm x 599 mm)
  • Basin Area, Top: 49-9/16″ x 25-1/2″ (1259 mm x 648 mm)

Product Usage Instructions

  1. Before using the product, ensure the hot water supply is at least 70% of the bath’s capacity.
  2. Connect the product to two dedicated circuits protected with a Ground-Fault Circuit Interrupter.
  3. Follow the installation instructions carefully to ensure proper setup.
  4. Experience the BubbleMassageTM feature for up to 60 minutes before turning it off.
  5. Use the hand shower to enhance your bathing experience.

FAQ

Q: What should I do if I encounter interference during faucet installation?

A: Ensure there is no interference above or below the deck before drilling any holes for a rim-mount faucet installation.

Q: Can I use the product without the air channels functioning?

A: It is recommended to have the air channels operating properly to enjoy the full benefits of the warm massage experience.

Q: How do I clean the product?

A: Recommended products for cleaning include Drain Treatment and Tub & Shower Cleaner. Follow the manufacturer's instructions for the best results.

Features

  • 118 to 122 air jets release thousands of heated bubbles that surround and support the body in a warm massage
  • Automatic and manual purge cycles remove residual water from air channels after use
  • Variable-speed blower lets you adjust massage intensity to 18 levels
  • The freestanding design creates a striking focal point in your bathing area
  • 16″ (406 mm) depth offers a deep soaking experience
  • Integral lumbar support on both ends
  • Textured bottom surface
  • The wide ledge on one side is ideal for the deck-mount faucet and/or hand shower
  • Fluted shroud
  • Built-in 600W BubbleMassage™ heater warms humidified air before it enters the bath
  • Automatic and manual purge cycles remove residual water from air channels after use

Material

  • Acrylic

Technology

  • The auto-shutoff timer on the blower allows users to enjoy the Heated BubbleMassage™ experience for 60 minutes before turning off
  • User interface: electronic keypad control

Installation

  • Center drain
  • PureFlo drains are not recommended for a deck-mount faucet installation
  • Remote blower motor installation required (relocation kit is included)

Dimension

Accessories

Required Products/Accessories

  • K-T37391 Rotary-turn bath drain trim
  • K-T37392 Rotary-turn bath drain trim
  • K-78438 30″ cable bath drain

Recommended Products/Accessories

  • K-7265 Brass toe tap bath drain
  • K-23726 Drain treatment
  • K-23732 Tub & shower cleaner

Codes/Standards

  • ASME A112.19.7/CSA B45.10
  • CSA B45.5/IAPMO Z124
  • ASTM E162
  • ASTM E662
  • UL 1795
  • CSA C22.2 No. 218.2
  • IAPMO Certification
  • cUL Listed
  • UL Listed

Available Colors/Finishes

Color tiles are intended for reference only.

Required Electrical Service

Two dedicated circuits are required, protected with Class A Ground-Fault Circuit-Interrupter (GFCI). Outside North America, this device may be known as a Residual Current Device (RCD).

  • Blower: 120 V, 15 A, 60 Hz
  • Heater: 120 V, 15 A, 60 Hz

Technical Information

All product dimensions are nominal.

  • Drain location: Center
  • Basin area, bottom: 39-5/8″ x 23-5/8″ (1006 mm x 599 mm)
  • Basin area, top: 49-9/16″ x 25-1/2″ (1259 mm x 648 mm)
  • Weight: 170 lbs (77.1 kg)
  • Minimum floor load: 50 lbs/ft² (244.1 kg/m²)
  • Water depth: 16″ (406 mm)
  • Water capacity: 60 gal (227.1 L)
  • Template: Footprint, 1364288, not required, not included
  • Electrical component rating:
    • Blower: 120 V, 10 A, 60 Hz
    • Heater: 120 V, 5 A, 60 Hz

Notes

  • Measure your actual product for rough-in details.
  • Install this product according to the installation instructions.
  • The hot water supply should be 70% of the capacity of the bath or greater. Installations will vary.
  • If installing a rim-mount faucet, make sure there is no interference above or below the deck before drilling any holes.

Warranty

KOHLER® Plastic Baths and Shower Bases Lifetime Limited WarrantyKOHLER® Hydrotherapy Components Five-Year Limited Warranty
See the website for detailed warranty information www.kohler.com.

Contact Information

  • 1-800-4KOHLER (1-800-456-4537)
  • Kohler Co. reserves the right to make revisions without notice to product specifications.
  • For the most current Specification Sheet, go to www.kohler.com USA or www.kohler.ca Canada 6-12-2024 20:40 – US

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals