KOHLER Rite-Temp K-8300-K Valve Body Rough-In Owner’s Manual
- July 10, 2024
- Kohler
Table of Contents
KOHLER Rite-Temp K-8300-K Valve Body Rough-In Owner’s Manual
Features
- Includes valve body, rough-in guide, and test cap
- 1/2″ Universal NPT and direct sweat inlets and outlets
- Requires valve cartridge and trim to complete installation (sold separately) Material
- Forged dezincification-resistant brass body provides long term reliability and resistance to aggressive water conditions
Installation
- Designed for use in standard, back-to-back and thin wall installations
- Valve body features integral mounting locations and symmetrical valve inlets to simplify installation
- Rough-in guide designed for both standard and thin wall installations
- Installed valve rough-in can be flushed and pressure-tested to 150 psi max (air or water) without cartridge by using included test cap
Required Products/Accessories
K-8305 Series Rite-Temp® Cartridges
Codes/Standards
ASME A112.18.1/CSA B125.1
KOHLER® Faucet Lifetime Limited Warranty
See website for detailed warranty information.
Technical Information
All product dimensions are nominal.
Notes
Install this product according to the installation guide.
Avoid cross-flow conditions. Do not install shutoff device on either valve
outlet.
Cap the shower outlet if deck-mount spout, diverter, or handshower is
connected to the spout outlet.
Install straight pipe or tube drop of 7″ (178 mm) to 18″ (457 mm) with single
elbow between valve and wall-mount spout.
For finished walls greater than 3/4″ (19 mm) and less than 1-1/2″ (38 mm),
install support(s) 2″ (51 mm) from the stud face.
For finished walls greater than 1-1/2″ (38 mm), install support(s) 3″ (76 mm)
from the face of the finished wall.
Kohler Co. reserves the right to make revisions without notice to product specifications. For the most current Specification Sheet, go to www.kohler.com USA or www.kohler.ca Canada 6-15-2024 19:49 – US