labelife P780BT Portable Label Maker User Guide
- July 10, 2024
- Labelife
Table of Contents
labelife P780BT Portable Label Maker
Charging until the power indicator doesn’t flash (fully charged).
- Pull the tape out through the tape guides about 1″ (3cm).
- Rotate the toothed wheel until it’s tightened.
Install the tape and pull out a section of the label about l” (3cm) from the paper outlet.
Print from Your Computer
Download “Labelife” Label Editor.
Note : the spelling of the [labelife] . There is ONLY ONE “L” in the
middle. Labelife is FREE software!
Print from Your Mobile Device
Turn on the printer.
Print from Your Mobile Device
3. Turn on Bluetooth from phone settings.
4. Connect the printer via Bluetooth in the Print Master App. (Enable GPS if you are using an Android device)
Specification
- Model P780BT
- Tape Width Available widths: 6mm. 9mm. 12mm. 18mm. 24mm
- Max Print Width 9mm
- Print Technology Thermal transfer
- Print Resolution 180 *180dpi
- Power Supply Lithium battery（1200mAh）
- Item Size 135(w)x130(d)x67(h)mm
- Supported Operating Methods Mobile Device/Computer
FCC Warning Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits fores lisi die designe o provide reason 5e protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure conditions without restriction.
IC Warning Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
IC RF exposure statement
The device has been evaluated to meet general IC RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>