Labelife D210S Label Maker Machine User Manual
- June 14, 2024
- Labelife
Table of Contents
D210S Label Maker Machine
User Manual
D210S Label Maker Machine
Dear customers,
Thank you for visiting!
Here are 3 tips for using label tapes:
- Make sure the end of tape is through both tape guides correctly.
- Before install, extend 1.5 inch (3-4cm) labels, kindly turn the green gear in the direction of arrow on the tape.
- Make sure the extended label tape passes through the outlet of label maker when install.
Note: Kindly follow above tips before EVERY installation to avoid damage.
Here attached the picture for your reference.
Tips for Installing Label Tape:
Kindly make sure the end of tape is through both tape guides correctly. Then
extend about 1.5 inch (3 cm to 4 cm) label tapes.
Tum the green gear in the direction of arrow on the tape until tight to
tighten the carbon ribbon.
When install, make sure the extended label tape passes through the outlet of
label maker.
Note: If you install the label tape after turning on the label maker, the label maker will remind you to choose the label width, kindly select “12 mm” for the included label tape.
If you have any problem or need on our product, please feel free to contact us
by Amazon’s direct message service (Click “sold by Labelife” on the product
page, then click “Ask a question”).
All messages or emails will be replied within 12 hours. We will do our best to
help you.
Hope all is well.
Thanks & Best Regards,
Labelife customer service team
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>