LAPIERRE Flipchip Trail Bikes User Manual
- July 9, 2024
- LAPIERRE
Table of Contents
LAPIERRE Flipchip Trail Bikes
INSTRUCTION FOR USE
- O VERVOLT AM
- ¾ OVERVOLT TR
- ¾ OVERVOLT e-EXPLORER
Attention: For drive-unit configuration need (regulation), any wheels size modification has to be settle by an approved professional reseller. Please consult your dealer shop for more information!
High
¾ More dedicated to 27“ rear tire
|
Mid
|
Low
¾ More dedicated to 29“ rear tire
---|---|---
|
| 
-
Turn the chainring so that the screws to the chain guide bracket are freely accessible.
-
Remove 2x countersunk screw from the chain guide bracket.
-
Remove chain guide bracket with screwed-on chain guide.
-
Remove the flip – chip screw and flip chip spacer on the non-drive side.
-
Remove the flip chip nut on the drive side outwards until just before the chainring, without removing it completely.
-
Turn the flip chip nut on the drive side to the desired position. The through hole of the flipchip spacer and the thread of the flip chip nut must remain aligned.
-
Refit the flipchip nut on the drive side into the frame (make sure it is form-fitted).
-
Turn the flip chip spacer on the non-drive side to the desired position. T he through hole of the flipchip spacer and the thread of the flip chip nut must remain aligned.
-
Refit the flip chip spacer and flip chip screw on the non-drive side into the frame (make sure it is form-fitted
-
Tight flipchip screw using relevant torque value = 8-10 Nm.
-
Refit the chain guide bracket with screwed-on chain guide.
-
Refit 2x countersunk screw from the chain guide bracket.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>