autoterm FC9 Fan Speed Controller User Manual
- June 6, 2024
- Autoterm
Table of Contents
FC9 FAN SPEED CONTROLLER
User’s manual
AUTOTERM FC9
AUTOTERM FC9 fan speed controller is designed for smooth fan speed control.
The FC9 fan speed controller goes perfectly together with the AUTOTERM CHX
heating matrices. The fan speed is controlled by moving the four sliders on
the front panel. The sliders can be connected to a CHX heating matrix or each
slider can be connected to an individual fan for more precise fan control.
The FC9 can be powered by any 12V power supply with a power of at least 600W.
In the BALTICA system the power source through a relay can be either FLOW 5
liquid heater or CHM36 thermal fan controller. The FC9 controller must be
mounted indoors where the humidity level doesn’t exceed 65%. For mounting the
FC9 controller, make a 147×41 mm opening and drill two ø3mm holes as shown in
Figure 1. Insert the controller in the opening and fasten the front panel with
the self-tapping screws from the kit.
For connecting FC9 controller see electrical connection diagram Figure 2. For
connecting FC9 with an additional CHM36 thermal controller see Figure 3.
The FC9 fan speed controller comes with four-wire extenders (50mm). There is a
3-pin connector (FC1) at the controller end and a 4-pin connector at the
other. The 4-pin connector allows to directly connection the fans of the CHX
heater matrices.
To extend the wires or to connect other devices, cut the 4-pin connector and
connect the wires according to the connection diagram.
TECHNICAL PARAMETERS
| Dimension: | 148.5 x 42.5 x 75 mm |
|---|---|
| Power output: | up to 50W per channel |
| DC Input: | +12V (standard 4-pin connector) |
| DC Output: | 0V-12V DC |
| Control Channels: | 4 |
| LED Colour: | White, Blue, Green, Cyan, Red, Purple, Yellow |
Manufacturer: AUTOTERM LLC
Paleju 72, Marupe, Latvia, LV-2167
Warranty Department [email protected]
Technical Support [email protected]
www.autoterm.com