SEALEY HT111LED Head Torch Instruction Manual
- June 12, 2024
- SEALEY
Table of Contents
SEALEY HT111LED Head Torch
Product Information
- Product Name: 5W COB LED Head Torch with Auto-Sensor
- Model Number: HT111LED
- Battery: Requires 3 x AA batteries (not included)
- LED Type: 5W COB
- Lumen Output: High – 350lm, Low – 80lm
Product Usage Instructions
Safety:
- DO NOT shine the torch directly into your, another person’s, or an animal’s eyes.
- DO NOT allow children to use the torch.
- DO NOT use the torch if you suspect that the battery or the torch casing is damaged.
- DO NOT leave batteries in the torch in a discharged state. Before storage, remove the batteries.
Battery Safety:
- DO NOT attempt to open the batteries.
- DO NOT crush, puncture, short contacts, or dispose of batteries in fire or water.
- Replace only with the batteries designed for this product.
- Recycle or dispose of used batteries as stipulated by local regulations.
- If battery electrolyte gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention.
Operation
Batteries: To remove the battery cover, twist the cap anticlockwise.
Insert 3 x AA batteries into the compartment according to the orientation
diagram inside the battery box. Replace the cap.
- Headlamp Operation:
- Full on: Press the On/Off button once.
- Flashing: Press the On/Off button twice.
- PIR mode: Hold down the On/Off button for more than 3 seconds.
- Dimmer Switch: Use the slider on top of the battery box to adjust the headlamp brightness.
- Rear Lamp:
- Full on: Press the On/Off button once.
- Flashing: Press the On/Off button twice.
Maintenance
- Keep the torch clean by wiping it with a damp cloth.
- Remove batteries if not being used for a long period of time.
- Store the torch and batteries in a dry childproof area.
Note: For further information on environment protection, recycling, and disposal, please refer to the user manual or contact your local solid waste authority.
5W COB LED HEAD TORCH WITH AUTO-SENSOR
MODEL NO: HT111LED
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
SAFETY
GENERAL
- DO NOT shine directly into your, another person’s or an animal’s eyes.
- DO NOT allow children to use the torch.
- DO NOT use the torch if you suspect that the battery or the torch casing is damaged.
- DO NOT leave batteries in torch in a discharged state. Before storage remove batteries.
BATTERY SAFETY
WARNING! To reduce the risk of burns or fire:
- DO NOT attempt to open the batteries.
- DO NOT crush, puncture, short contacts or dispose of in fire or water.
- DO NOT expose to temperatures above 60°C (140°F).
- Replace only with the batteries designed for this product.
- Recycle or dispose of used batteries as stipulated by local regulation.
- If the electrolyte in the batteries gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention.
INTRODUCTION
Hands-free 5W COB LED spotlight with 40° angle adjustment. Dimmer switch allows brightness to be adjusted from 20% to 100%. Main light has one switch with 4-functions, on, flash, auto-sensor and off. Automatic sensor turns on and off when you move your hand in front. Rear of strap includes a red LED warning light which has 2-functions, flash or on, ideal for a cycling light. Adjustable headband and foam brow for added comfort. Powered by 3 x AA batteries (not included).
SPECIFICATION
- Model No:…………………………………………………….HT111LED
- Battery: …………………………………………. 3 x AA (not included)
- LED Type: ……………………………………………………….5W COB
- Lumen Output: …………………………….High; 350lm, Low; 80lm
OPERATION
- BATTERIES
- To remove battery cover twist cap (anticlockwise to open).
- Insert 3 x AA batteries into compartment. Orientation diagram for batteries is inside battery box, replace cap.
- HEADLAMP OPERATION (fig.1)
- Full on: Press On/Off button once.
- Flashing: Press On/Off button twice.
- PIR mode: Hold down On/Off button for more than 3 seconds.
- DIMMER SWITCH (fig.2)
- Slider on top of battery box to adjust headlamp brightness.
- REAR LAMP (fig.2)
- Full on: Press On/Off button once.
- Flashing: Press On/Off button twice.
MAINTENANCE
- Keep the torch clean by wiping with a damp cloth.
- Remove batteries if not being used for a long period of time.
- Store torch and batteries in a dry childproof area.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and
disposed of in a manner which is compatible with the environment. When the
product becomes completely unserviceable and requires disposal, drain any
fluids (if applicable) into approved containers and dispose of the product and
fluids according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the
EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the
product is no longer required, it must be disposed of in an environmentally
protective way. Contact your local solid waste authority for recycling
information.
BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd
are required to inform potential purchasers of products containing batteries
(as defined within these regulations), that they are registered with Valpak’s
registered compliance scheme. Jack Sealey Ltd Batteries Producer Registration
Number (BPRN) is BPRN00705.
Note: It is our policy to continually improve products and as such we
reserve the right to alter data, specifications and component parts without
prior notice.
Important : No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is
required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk.
IP32 7AR
01284 757500 sales@sealey.co.uk
www.sealey.co.uk