Audickic FX-3917-00 4-Light Double Shaded Semi Flush Mount Chandelier Installation Guide
- July 8, 2024
- Audickic
Table of Contents
Audickic FX-3917-00 4-Light Double Shaded Semi Flush Mount Chandelier
Specifications
- Model: FX-3917-00
- Fixture Type: Chandelier
- Socket Type: E26
- Maximum Wattage per Socket: 40 Watts
- Number of Sockets: Up to four (4)
- Indoor Use Only
Product Usage Instructions
- Installation Steps:
- Pass the wires through the tubes (B) and canopy (D) and tighten the lamp body (A), tube (B), and canopy (D).
- Remove mounting bracket (E) from the canopy (D) and attach it to the junction box using screws (F).
- Make electrical connections using wire nuts (G).
- Attach the canopy (D) to the mounting bracket (E) and secure it with nuts (C).
- Gently pull to unfold the inner shade.
- Install the light diffuser (H).
- Install light bulbs (not included).
FAQs
- Q: What is the maximum wattage for each socket?
- A: The fixture is rated for up to four E26 sockets with a maximum of 40 Watts per socket. Do not exceed the recommended lamp wattage.
- Q: Can this chandelier be used outdoors?
- A: No, this lighting fixture is meant for indoor use only.
- Q: Are the mounting bracket and junction box included?
- A: The junction box is not included. The mounting bracket, screws, wire nuts, canopy, and other necessary hardware are included for installation.
PRODUCT INTRODUCTION
WARNING:
THIS PRODUCT MUST BE INSTALLED FOLLOWING THE APPLICABLE INSTALLATION CODES BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
- Check for electric, gas, & plumbing lines before drilling or consult a professional.
- Turn off your electricity at the circuit breaker or main fuse box before installation.
- Do not restore power to the line until fully installed.
- Do not exceed the recommended wattage.
- Always allow bulbs to cool for 10 minutes before changing.
This fixture has been rated for up to four (4) E26 Socket 40-Watt maximum light bulbs (not included). To avoid the risk of fire, DO NOT EXCEED THE RECOMMENDED LAMP WATTAGE. The lighting fixture is meant for indoor use.
INSTALLATION STEPS
Pls read the installation instructions carefully and follow the steps:
- Pass the wires through the tubes (B) and canopy (D). Then tighten the lamp body (A), tube (B), and canopy (D).
- Remove the mounting bracket (E) from the canopy (D). Attach mounting bracket (E) to junction box with screws (F). The junction box is not included.
- Make electrical connections using wire nuts (G).
- Attach the canopy (D) to the mounting bracket (E) and secure it with nuts (C).
- Gently pull to the unfolded inner shade.
- Install the light diffuser (H).
- Install the light bulbs (not included).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>