EATON FlexiTech Safety Escape AT LED Instruction Manual
- June 3, 2024
- EATON
Table of Contents
EATON FlexiTech Safety Escape AT LED
OVERVIEW
Installation
Intended used
Disconnect the battery, wait for 10 seconds, and reconnect it if you decide to
change the configuration (steps 2-3).
If the battery duration is insufficient, replace the battery. When the lifetime of the light source is over, replace the luminaire WEEE: Contact your local dealer Eaton.com/recycling
ZNO2047300 A- 05/2021 Eaton is a registered trademark. All trademarks are the property of their respective owners.
- White flexible material
- Blue flexible material
- Break through a cable entry using a screwdriver.
- Rigid or flexible wire
- If cable entry on the right
- Drill in the honeycomb zones (IP43) or in the flexible material (IP65/IP43).
- Drilling zones to avoid
- Cabling of connectors with a screwdriver.
- Cabling of connectors by hand.
- Check the packaging for the whole cabling details.
- Non-maintained
- Maintained
- Autotest
- Charge / Lamp / Battery
- 1wk / 26wks
- LED Description
- Green / Yellow
- Constant / Blinking
- Disconnect the battery, wait for 10 seconds, and reconnect it if you decide to change the configuration (steps 2-3).
- Magnet Test
- Functional Test
- Duration Test
- Reset luminaire
- DIM level
- Green / Yellow
- Replaceable
- Not replaceable
- Battery pack, Order code
- If the battery duration is insufficient, replace the battery.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>