UREVO URRC01 Remote Controller Instruction Manual

UREVO URRC01 Remote Controller

Specifications

• Model: URRC001 / URRC002
• Version: 1.0
• Functions: Start/Stop/Pause, Speed +/-, Incline +/-, Mute
• Battery: Requires batteries (not included)

Product Usage Instructions

Installation

1. Open the cover of the remote controller and install the batteries.
2. Install the back cover and tighten the screws securely.

Operation of Remote Controller

• Start/Stop: Short press to start the walking treadmill. Long press to stop completely.
• Pause: Short press to pause and preserve workout data. The display will show “PAU”.
• Speed +/-: Adjust the walking belt speed incrementally by 0.2mph with each press.
• Incline +/-: Adjust the incline level up or down by pressing the respective buttons.
• Mute: Short press to mute buzzer voices.

Safety Instructions

1. Do not swallow or insert any part of the remote controller into the body.
2. Avoid making any changes or modifications not approved by the responsible party.
3. Ensure compliance with FCC regulations for interference prevention.

FAQ

• Q: How do I change the workout goals on the remote controller?
• A: You can customize workout goals such as Time, Calories, or Distance by using the +/- buttons to select and set parameters according to your exercise needs.
• Q: What should I do if the display turns off during a pause?
• A: If the display turns off during a pause lasting longer than 10 minutes, simply press any button to reactivate the display.

IMPORTANT: Read all instructions carefully before using this product. Retain this owner’s manual for future reference. The specifications of this product may vary from this photo, subject to change without notice.

FUNCTION

URRC001

Operation of Remote Controller

Stop

|

Long press for 2″

| The display shows “End” and the walking belt slows down until completely stops.

Pause

|

Short press (in start mode)

| Pause while exercising, walking belt slow down until completely stops, the display shows ” PAU” and the workout data will be preserved, re-press this button to resume. Display off if pause longer than 10 minutes.
| Accelerate| Short press| Walking belt speed up, the increment is

0.2mph.

| Decelerate| Short press| Walking belt speed down, the decrement is

0.2mph.

| Mode| Short press| Customize workout goals (Ex: Time; Calories;

Distance).

Users can freely set parameters according to their own exercise needs and select them through the ” -, + ” buttons.

| Silence| Short press| Short press: Muted buzzer voices

URRC002

Operation of Remote Controller

down until completely stops.
Pause| Short press (in start mode)| Pause while exercising, the walking belt slows down until completely stops, the display shows ” PAU” and the workout data will be preserved, re-press this button to resume. Display off if pause longer than 10 minutes.
| Incline +| Short press| Increase incline level.
| Incline –| Short press| Decrease incline level.
| Accelerate| Short press| Walking belt speed up, the increment is

0.2mph.

| Decelerate| Short press| Walking belt speed down, the decrement is

0.2mph.

Warning!

1. Remove and immediately recycle or dispose of used batteries according to local regulations and keep them away from children. Do NOT dispose of batteries in household trash or incinerate them.
2. Even used batteries may cause severe injury or death.
3. Call a local poison control center for treatment information.
4. The compatible battery type is CR2032 3V.
5. Non-rechargeable batteries are not to be recharged.
6. Do not force discharge, recharge, disassemble, heat above 50°C/122°F or incinerate. Doing so may result in injury due to venting, leakage, or explosion resulting in chemical burns.
7. Ensure the batteries are installed correctly according to polarity (+ and -).
8. Do not mix old and new batteries, different brands, or types of batteries, such as alkaline, carbon-zinc, or rechargeable batteries.
9. Remove and immediately recycle or dispose of batteries from equipment not used for an extended time according to local regulations.
10. Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep them away from children.

WARNING

• INGESTION HAZARD: This product contains a button cell or coin battery.
• DEATH or serious injury can occur if ingested.
• A swallowed button cell or coin battery can cause Internal Chemical Burns in as little as 2 hours
• KEEP new and used batteries OUT OF REACH of CHILDREN
• Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.

FCC STATEMENT

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
3. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, according to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with RSS210 of Industry Canada. Cetappareil see conforme à RSS210 de Canada d’Industrie. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device. appareils radio exempts de licence

Radiation Exposure Statement: The product complies with the Canada portable RF exposure limit set forth for an uncontrolled environment and is safe for intended operation as described in this manual.
The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such a function is available.

This Class B digital apparatus complies with Canadian ICES-003.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>