UREVO URTM025 Spacewalk E1 Walking Treadmill User Manual
- June 13, 2024
- UREVO
Table of Contents
- UREVO URTM025 Spacewalk E1 Walking Treadmill
- IMPORTANT SAFETY INSTRUCTIONS
- GROUNDING INSTRUCTIONS
- FCC STATEMENT
- SAFETY NOTICE
- SPECIFICATION
- PRODUCT AND ACCESSORIES
- PRODUCT INTRODUCTION
- BEFORE START AND STORAGE
- FUNTION MENU
- REMOTE CONTROLLER
- TROUBLESHOOTING
- CARE AND MAINTENANCE
- Appliance cleaning
- WARRANTY
- CUSTOMER SERVICE
- Documents / Resources
UREVO URTM025 Spacewalk E1 Walking Treadmill
IMPORTANT SAFETY INSTRUCTIONS
DANGER – To reduce the risk of electric shock:
- Always unplug this appliance from the electrical outlet immediately after using and before cleaning.
WARNING-To reduce the risk of burns, fire, electric shock, or injury to persons:
- An appliance should never be left unattended or plugged in. Unplug from outlet when not in use, and before putting on or taking off parts.
- Do not operate under a blanket or pillow. Excessive heating can occur and cause fire, electric shock, or injury to persons.
- Close supervision is necessary when this appliance is used by, on, or near children, invalids, or disabled persons.
- Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
- Never operate this appliance if it has a damaged cord or plug if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the appliance to a service center for examination and repair.
- Do not carry this appliance by supply cord or use cord as a handle.
- Keep the cord away from heated surfaces.
- Never operate the appliance with the air openings blocked. Keep the air openings free of lint, hair, and the like.
- Never drop or insert any object into any opening.
- Do not use outdoors.
- Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
- Caution – To reduce the risk of injury from moving parts – Unplug before servicing.
- Warning – To reduce the risk of Electric shock – Unplug before cleaning or servicing.
- Warning – Risk of personal injury – Keep children under the age of 13 away from walking treadmill.
- To disconnect, turn all controls to the position, then remove the plug from the outlet.
- Connect this appliance to a proper outlet only. See grounding instructions.
- This appliance is not intended for use by persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Keep children under the age of 13 away from this walking treadmill.
- The maximum weight capacity for this product is 242 kg/110kg. DO NOT EXCEED MAXIMUM WEIGHT CAPACITY.
SAVE THESE INSTRUCTIONS
GROUNDING INSTRUCTIONS
This product must be grounded. If it should malfunction or break down,
grounding provides a path of least resistance for electric current to reduce
the risk of electricity and a grounding plug. The plug must be plugged into an
appropriate outlet that is properly installed and grounded in accordance with
all local codes and ordinances.
DANGER – Improper connection of the equipment-grounding conductor can
result in a risk of electric shock. Check with a qualified electrician or
serviceman if you are in doubt as to whether the product is properly grounded.
Do not modify the plug provided with the product – if it will not fit the
outlet, have a proper outlet installed by a qualified electrician.
FCC STATEMENT
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
- This device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SAFETY NOTICE
SPECIFICATION
Performance indicators| Detailed parameters| Performance
indicators| Detailed parameters
---|---|---|---
Product dimension
| 119 x 49 x 12 cm|
Minimum speed
|
0.6 mph
46.8 x 19.3 x 4.8 inch
Walking Area
| 38 x 102 cm|
Maximum speed
|
4.0 mph
15 x 40.2 inch
Gross weight
| 21.2 KG|
Rate voltage
|
110 – 120V –
46.7 Lbs
Net weight
| 18.2 KG|
Maximum load
| 110 KG
40.1 Lbs| 242 Lbs
Peak horsepower| 2.25Hp| Rated power| 550W
PRODUCT AND ACCESSORIES
- Please carefully check whether the contents of the package are complete and intact.
- If there is any missing or damage, please contact the seller.
Accessories
PRODUCT INTRODUCTION
BEFORE START AND STORAGE
Take out appliances from packages
-
Unbox and take out the accessory box.
-
Lift out the appliance and place at flat surface.
Attention: 2-3 persons assist is necessary. -
It’s normal that visible welding marks are residual on the walk belt.
Transportation
- If transportation is needed, unplug the power cord and lift the terminal of the appliance.
- Easy to transport appliance with bottom transportation wheel assists, like a wheelbarrow.
Connect the power
- Choose flat ground to place the Walking Treadmill. Do not place it on a thick and soft cushion.
- Plug in the power cord and switch on the power rock button, you can hear a BI sound from the buzzer, which means the circuit of the appliance has been connected with power electricity.
Warning: MUST use the power cord that with comes of package.
Warning
- Before starting to workout with this product, Please assess your physical condition and perform exercise properly and regularly. Incorrect or excessive training can be harmful to your health, If you feel unwell, Stop exercising immediately and consult with your doctor.
FUNTION MENU
Tips: The workout datas (Calorie; Time; Step; Distance; Speed) will be alternated display Per 4 seconds.
REMOTE CONTROLLER
Note: Ensure that the walking treadmill is power on and the remote control is installed with batteries.
Operation of Remote Controller
Buttons | Operation | Note |
---|---|---|
Short press | Start the walking treadmill |
Long press for 2″
| When the walking treadmill stop (all datas recover to0 ), the screen will display “END”. 10 minutes later, the system will switch to the economic mode and turn off the display screen; Press any buttons to wake up the treadmill.
Short press (in start mode)
| The screen will display “PAU”, previous workout metrics will be preserved automatically if pause time no longer than 10minutes, otherwise metrics data will be recovered to “0”; Press any buttons to wake up the treadmill.
The treadmill will re-start at the minimum speed by re-pressing .
MODE| Short press| Customize countdown workout programs ( like as: Time; Distance; Steps;
Calories)
| Short press| Long press over 0.5 seconds, the speed will be increased
continuously.
| Short press| Long press over 0.5 seconds, the speed will be decreased
continuously .
| Short press| Short press: Muted buzzer voices
ERROR CODE
- When error occurs, error warning indicator will light up and display its error code.
Error Code | Fault Analysis | Resolutions |
---|---|---|
E01 | **** |
Communcation interrupted.
| Unscrew motor hood to verify signal cable whether was pinched or terminal loosen.
E02
| ****
The motor wire is loose or failing off, or the carbon brush is worn out.
| Check whether the motor cable is loose or failing off. If it does not fall off, check whether the carbon brush of the motor is worn out. If it is worn out, replace the motor. If it is not worn out, the electric controller is damaged. Replace the electric controller.
E05
| ****
Overloading protection
| 1. User weight over limited 110KG.
2. Removal foreign bodies which causes of roller or walking belt.
3. Inject lubricants.
E06| System self-check failed.| System failure. Replace cont roller.
Abnormal
display
| External disturbance.| Turn off power switch, turn on it after one minute.
Not only error code appeared but also built in buzzer alarm, Once error code and alarm happened, you MUST stop workout immediately, Please contact with after sale service if problem CAN NOT be solved after restart.
TROUBLESHOOTING
CARE AND MAINTENANCE
Symptom : walk belt off centered or slips
Centering walk belt process as follow
- Power off appliance and unplug the power cord .
- Manual centering process as follow:
- If the walk belt has shifted to left, use the hex tool to turn the left idler roller screw clockwise 1/4 of a turn(refer to figure 1 ).
- If the walk belt has shifted to right, use the hex tool to turn the right idler roller screw clockwise 1/4 of turn(refer to figure 2).
- Appliance MUST work 1-2mintutes. Repeat manual centering process untill the walk belt is centered.
Belt slip correcting process as follow
-
Power off appliance before operation.
-
Using the hex tool, turn both idler roller screws clockwise 1/2 ofturn(refer to figure 3).
-
After corrected, please attempts to walking 1-2 minutes under 1.0 mph speed setting. Repeat until the walk belt is properly tightened.
Attentions
- To prevent any injury, don’t place any debris around appliance before maintenance process.
- MUST use associated hex tool.
- Take care at maintenance process. Do not pinch fingers.
Belt lubrication process, follow instruction below to lubricate belt
-
Power off appliance and unplug cord.
-
Using the hex tool, turn both idler roller screws counterclockwise till belt loosen and lifting easily.
Tips: please markdown hex tool rotating cycles when loosen belt, which use for adapting belt tension after lubrication process. -
Lifting edges of belt and spraying lubrication oil at center of walk platform evenly. Not necessary to apply spray lubrication oil on entire walk platform.
-
Lubrication oil volume Per time of maintenance: 5-10ml.
Attention: it would causes of belt slip if spray too much. -
Using the hex tool, turn the both idler screws clockwise as previous markdown number of turns untill walk belt tighten properly.
-
Power on appliance and workout for a few minutes, in order to spread lubrication oil to whole belt surface evenly.
Attention: No-loading work at 1.0mph speed setting
Lubrication frequency: High recommend 125 Miles Per time.
Appliance cleaning
- Power off appliance and unplug power cord before cleaning.
- Wipe and clean with damp cloth, Do not cleaning with acidic or caustic detergents.
- Do not clean opposite of walk belt.
- Its normal few black powders residual under appliance after long working.
WARRANTY
MANUFACTURER’S LIMITED WARRANTY
UREVO warrants to the original purchaser that this product is free from
defects in material and workmanship when used for the purpose intended, under
the conditions that it has been installed and operated in accordance with
UREVO Owner’s Manual. UREVO’s obligation under this warranty applies to the
following:
COMPONENT LENGTH OF WARRANTY
- Structural Frame 1 year For Home Use Only
- All Other Components 90 days For Home Use Only
Exclusions from Warranty Coverage
UREVO does not warrant against and is not responsible for, and no implied
warranty shall be deemed to cover, any product failure, product malfunction,
or damages attributable to:
- Improper installation and/or failure to abide by UREVO’s installation guidelines;
- Use of this product beyond normal home use, or in an application for which it was not designed;
- Cosmetic items such as scratches, dents or discolorations;
- Damage caused by normal wear and tear, vandalism, accidental or by animals;
- Any act of Nature (such as fire, flooding, snow, ice, hurricanes, earthquakes, lightnings or other natural disasters), environmental condition (such as air pollution, mold, mildew, etc.), or staining from foreign substances (such as dirt, grease, oil, etc.);
- Normal weathering due to exposure to sunlight, weather and atmosphere which can cause colored surfaces to among other things, flake, chalk, accumulate dirt or stains.
- Improper operation, alteration, handling, storage, abuse or neglect ofthe products.
UREVO , using its sole discretion, will either repair or replace free of
charge any part(s) proven to be defective under normal home use. Any repair or
replacement shall provide no new warranty coverage, but shall retain only the
remaining portion of the original product’s warranty.
This warranty is offered only to the original purchaser and is not
transferable. Proof of original purchase is required.
When ordering replacement parts please have the following information ready:
- Order Number
- Description of Parts (Adding photos or videos would be helpful)
- Part Number
- Date of Purchase
IMPORTANT: Read all instructions carefully before using this product.
Retain this owner’s manual for future reference.
The specifications of this product may vary from this photo, subject to change
without notice.
Manufacturer: Shenzhen Vile Dynamic Technology Co., LTD
- Address: 1205-1206, Tianliao Building, Tangchang Road, Tanglang
- Community, Taoyuan Street, Nanshan District, Shenzhen, China
CUSTOMER SERVICE
IMPORTANT: FOR UREVO ONLY
- For damaged or defective product, questions, replacement parts or any other service support, please contact our customer service department by the below methods:
- services@urevosports.com.
- Response Time: 24-48 hours
- Emailing us with the Order ID will be the best method to receive a response during peak business hours.
- Website: www.urevosports.com.
- US Support Hotline: (1 )844-998-2473
- Hours of Operation:
- Monday – Friday : 9 AM – 12 PM; 1 PM – 6 PM (PST)
PLEASE DO NOT RETURN THIS PRODUCT WITHOUT ASKING OUR CUSTOMER SERVICE FIRST
SCAN THIS QR CORD TO GET THE PRODUCT INSTALLATION OR MAINTENCE VIDEOS
Documents / Resources
|
UREVO URTM025 Spacewalk E1 Walking
Treadmill
[pdf] User Manual
URTM025 Spacewalk E1 Walking Treadmill, URTM025, Spacewalk E1 Walking
Treadmill, Walking Treadmill, Treadmill
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>