CENTEK CT-2573 Vacuum Cleaner Instruction Manual

: July 2, 2024
: CENTEK

Table of Contents

SAFETY PRECAUTIONS
DESCRIPTION OF THE DEVICE
COMPLETENESS
OPERATION PROCEDURE
MAINTENANCE OF THE DEVICE
SPECIFICATIONS
DISPOSAL
CERTIFICATION DATA, GUARANTEE
MANUFACTURER AND IMPORTER INFORMATION
Documents / Resources

CENTEK CT-2573 Vacuum Cleaner

DEAR CUSTOMER!
Thank You for purchasing a CENTEK brand product. We guarantee flawless function of this item, provided the guidelines of its operation are observed.

PURPOSE OF THE DEVICE
For cleaning dust and dirt from hard and soft surfaces (hard floor, carpet, etc.).

The vacuum cleaner is a home appliance and is not designed for industrial applications.

SAFETY PRECAUTIONS

The following requirements should be strictly observed in order to avoid situations hazardous for human life and health, as well as premature failures of the appliance:

Carefully read the present manual prior to operating the appliance.
Retain the present manual, cash voucher and appliance packaging.
Before operating the appliance ensure that the power supply grid voltage corresponds to that indicated on the charger.
Connect the appliance for charging only to power grid sockets equipped with earthing contacts, use only two-pole extension cables with 10 A rating and an earthing conductor.
The appliance should be turned off during charging.
Never charge the cleaner at ambient temperatures above 37 °C and below 0 °C.
The charger may become hot during charging.
Always disconnect the charger from the electric socket after fully charging the battery. Pull the charger connector from the charger socket of the appliance before use and any cleaning and maintenance operations.
Do not leave the appliance near sources of heat.
Do not obstruct the air exhaust grille.
Do not use methyl alcohol and other solvents for cleaning the appliance.
Do not use the vacuum cleaner to collect liquids.
Only the use of original spare parts is allowed. Do not use accessories which are not included in the scope of supply.
Do not turn the appliance on if it is damaged or malfunctioning.
Do not charge the appliance if its power cable or plug is damaged, if doesn’t run smoothly or has been dropped.
Do not attempt to repair the appliance yourselves.
If the charger is damaged it should be replaced by the Manufacturer, a service facility or other skilled personnel.
Do not submerge the appliance in water or any other liquids.
The appliance should not be used by physically, sensory or mentally handicapped persons (including children) or by persons without sufficient experience or knowledge, unless such persons are under supervision, or have been instructed on the use of the appliance, by the persons responsible for their safety. Take precautions not to children play with the appliance.
Special instructions for transportation (shipment) and sale: none.
Should You decide to transfer the appliance to another person, please pass the present manual over along with it.

Do not use the appliance on wet surfaces

Do not use the appliance to collect smoldering matches, cigarette stubs or tobacco ash

Do not use the appliance to collect needles, drawing pins, paper clips, etc.

DESCRIPTION OF THE DEVICE

Ergonomic handle
On/off button
Dust container opening button
Dust collector
Pipe release button
Aluminum pipe
Accessory release button
Electric brush
Vacuum cleaner operation indicators
Mode switch button
Removable battery pack
Frame
Narrow nozzle
Brush attachment 2 in 1
Network adapter
Wall mount

COMPLETENESS

Main body – 1 pc.
Narrow nozzle – 1 pc.
Brush attachment 2 in 1 – 1 pc.
Adapter – 1 pc.
Aluminum pipe – 1 pc.
Electric floor brush – 1 pc.
Wall mount – 1 pc.
Self-tapping screw – 2 pcs.
Dowel – 2 pcs.
HEPA filter – 1 pc.
Foam filter – 1 pc.
User manual – 1 pc.

OPERATION PROCEDURE

ASSEMBLY OF THE DEVICE

Attach the aluminum pipe to the main body of the device.
Insert an electric brush into the other end of the aluminum pipe.
Connect the adapter to the device, insert the adapter block into a socket with a voltage of 220-240 V.
Before using for the first time, charge the vacuum cleaner for 5 hours, after which it is fully charged. For subsequent use, the normal charging time will be 4 hours.
When charging is complete, disconnect the adapter from the outlet and from the device.
Secure the plastic wall mount (16) using the screws and dowels included in the kit ( Fig. 1). Install the vacuum cleaner and additional attachments (13, 14) onto the mount.

OPERATING THE DEVICE AS A VERTICAL VACUUM CLEANER

| Mode 1 indicator| | Mode 3 indicator
---|---|---|---
| Mode 2 indicator| |
---|---|---|---

Press the on/off button (2) to turn on the vacuum cleaner.
Using the mode switching button (10), select the operating mode of the vacuum cleaner: 1, 2, 3. When selecting a mode, the corresponding indicator will light up.
When the battery charge is 20%, switching to high mode is impossible.
The device will operate in minimum mode.

OPERATION/CHARGING INDICATION

While the vacuum cleaner is operating, the selected mode indicator and the green vacuum cleaner operating indicators (9) will light up.
When the device is connected to a power source, the battery will charge, the indicators (9) will light up alternately.
If a fault occurs, the indicators (9) will flash simultaneously.
As the battery discharges, the indicators (9) go out one by one until the last flashing indicator remains. Connect the device to the network.

ATTACHMENTS FOR HANDHELD VACUUM CLEANER

| NARROW NOZZLE Suitable for cleaning nooks and crannies in windows or doors.| | BRUSH AT TACHMEN T 2 IN 1 Suitable for cleaning fabric furniture such as bed, sofa.
---|---|---|---

Please remove the aluminum tube from the device and install a narrow nozzle or brush attachment on the body of the device.
The 2 in 1 brush attachment has 2 positions. To re-fluff, press the button on the brush and move it up and down.

MAINTENANCE OF THE DEVICE

CLEANING THE FLOOR BRUSH

Press the latch at the bottom and remove the cover latch.
Remove the rotating roller.
Remove hair and debris from the roller with your fingers or a knife.
Rinse the roller under running water.
Dry the roller completely before reassembling.
Reinstall the rotating roller. Slide the lock to its previous position.

DUST REMOVAL

Method 1: Press the dust bin open button (3), empty the dust bin.
Method 2 : Remove the dust collector from the device body by turning it counterclockwise. Press the dust bin opening button (3). Empty the dust bin.

CLEANING THE FILTERS

Press the button on the bottom of the dust bin (3) to open it.
Insert a narrow nozzle into the grooves, fix it, turn it counterclockwise, and remove the plastic filter.
Remove the HEPA filter from the plastic filter and clean it.
After cleaning, reassemble the device.

We strongly recommend observing the following maintenance rules;
they will help retain the suction capacity and quality performance of the CENTEK TM vacuum cleaner. This is also the prerequisite for free guarantee maintenance.
Do not wash the filter in a washing machine and do not dry it with a hair drier.

Check the dust collector and filter after each use of the cleaner. Failure to do this may cause a suction capacity reduction and failure of the appliance.

BATTERY REPLACEMENT

For reasons of safety the Lithium-Ion batteries in this cleaner are only replaceable by a service engineer. When the batteries fail to maintain charge, please contact the Customer Service Centre to arrange a replacement.

END OF PRODUCT LIFE BATTRTY REPLACEMENT

If the cleaner is to be disposed off the batteries should be removed. Used batteries should be taken to a recycling station and not disposed whit household waste. To remove the batteries, please contact the Customer Service Centre or proceed according to the following instructions:
IMPORTANT: Always fully discharge the batteries before removal and ensure charger is unplugged.

Run the unit until the batteries are completely empty.
Release the handheld unit from the main body of the cleaner.
Press the dust container release button and remove the dust container.
Remove 6 screws and open the unit.
Remove the motor /battery housing and disconnect the cables.
Remove the batteries from the housing.

NOTE: Should you experience any difficulties in dismantling the unit or for more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service.

TROUBLESHOOTING

Problem

|

Probable Cause

|

Remedy

---|---|---
Poor suction|

Dust collector full
Filter contaminated
Brush clogged

|

Clean the dust collector
Clean the filters
Clean the brush

Appliance will not function|

Battery depleted
Overheat protection trips
Suction opening or tube clogged

|

Charge the battery
Wait for the appliance to cool down
Clean the suction opening or tube

Appliance emits abnormal noise during operation| Suction opening or tube clogged| Clean the suction opening or tube
Charge indicator not working|

Defective power adapter
Power adapter not connected
Defective battery

|

Check power adapter for proper connection
Contact a service center

Battery overcharge| Battery temperature too low or too high| Charge the battery after its temperature normalizes

SPECIFICATIONS

Charger (power adapter

Nominal rated supply voltage

|

220–240 V ~50/60 Hz

Nominal output voltage

|

26,5 V 0,5 А

Power rating

|

13,25 W

Protection Class

|

II

Appliance

Power supply| Li-Ion Battery| Current| 2200 mAh; 22,2 V 0,5 А

Nominal power rating

|

215 W

---|---

Maximum power rating

|

400 W

Suction capacity

|

19000 Pa

Protection Class

|

III

Electric brush

Nominal rated voltage

|

22,2 V

Nominal power rating

|

15 W

Model

|

СТ-2573-brush

Continuous operating time:
1 mode – 45 min;
2 mode – 30 min;
3 mode – 14 min.
Dust container capacity: 0.8 l 2573
Time to full battery charge: 4-5 hours

ATTENTION! The device should only be used with the power supply supplied with the device.

DISPOSAL

Upon expiry of its service life the appliance can be disposed of separately from ordinary domestic waste. You can turn it over to a specialized electric and electronic appliance disposal and recycling centre.

CERTIFICATION DATA, GUARANTEE

The service life of this item is 5 years since the date of sale to the end user, provided the item will be used in strict accordance with the present manual and the applicable technical standards. Upon expiry of the service life please contact the nearest authorized service centre for suggestions as to further operation of the appliance. The manufacturing date of the appliance is integrated into the serial number (digits 2 and 3 – year, digits 4 and 5 – month of manufacture). If any questions related to appliance maintenance should arise, or if the appliance has malfunctions, apply to the CENTEK TM Authorized Service Center. The address of the service center can be found on the website https://centek.ru/servis. Service support contacts: Phone: +7 (988)
24-00-178, VK: vk.com/centek-krd. General Service Center: OOO «Larina Servis», Krasnodar, Phone: +7 (861) 991-05-42. The product is provided with the Certificate of Conformity.

MANUFACTURER AND IMPORTER INFORMATION

Imported to EAEU by: Individualniy Predprinimatel Asrumyan Karo Shurikovich. Address: Russia, 350912, Krasnodar, ul. Atamana Lysenko, 23, pgt. Pashkovskiy. Phone: +7 (861) 2-600-900.

DEAR VALUED CONSUMER!

The guarantee period for all appliances amounts to 12 months since the date of sale to the end consumer. With this Warranty Card the Manufacturer confirms the proper condition of the appliance and undertakes to repair, free of charge, all defects caused by the Manufacturer’s default.

GUARANTEE MAINTENANCE TERMS

The guarantee shall be valid if the following documentation conditions
are observed:
- The original Warranty Card shall be filled out correctly and clearly, indicating the of appliance model, serial number and sale date, the stamp of the seller company and signature of its representative shall be available, as well as the stamps on each coupon and the buyer’s signature in the Warranty Card.
  The Manufacturer reserves the right to reject guarantee maintenance if the buyer fails to provide the abovementioned documents or if the information contained therein is incomplete, illegible or ambiguous.
The guarantee shall be valid if the following operation conditions are observed:
- the appliance is used in strict accordance with the present manual;
- the safety rules and requirements are observed.
The guarantee does not apply to regular maintenance, cleaning, installation and setup of the appliance at the owner’s location.
The guarantee does not apply in the following cases:
- mechanical damage;
- normal wear of the appliance;
- non-observance of operation requirements or erroneous actions on the part of the user;
- improper installation or transportation;
- natural disasters (lightning, fire, flood, etc.), as well as any other causes beyond the Manufacturer’s or Seller’s control;
- ingress of foreign objects, liquids or insects into the inside of the appliance;
- repairs or modifications to the appliance by unauthorized persons;
- use of the appliance for commercial purposes (loads exceeding normal domestic application), connection of the appliance to utility and telecommunication networks incompliant with national technical standards;
- failure of the following accessories, if replacement of these is allowed by design and does not involve disassembly of the appliance:
  a) remote control units, rechargeable batteries, replaceable batteries (power cells), external power supply units and chargers;
  b) consumables and accessories (packaging, covers, slings, carry bags, mesh screens, blades, flasks, plates, supports, grilles, spits, hoses, tubes, brushes, nozzles, dust collectors, filters, smell absorbers);
- for battery-powered appliances – operation with inappropriate or depleted batteries;
- for rechargeable battery-powered appliances – any damage caused by improper battery charging and recharging.
The present guarantee is provided by the Manufacturer in addition to the consumer rights determined by the applicable legislation and does not limit these rights in any way.
The Manufacturer shall not be made liable for possible damage, directly or indirectly inflicted by CENTEK brand products on people, domestic animals, the consumer’s or third persons’ property if such damage is inflicted as the result of non-observance of appliance installation and operation requirements, deliberate or negligent actions (omission) by the consumer or third persons, as well as of force majeure circumstances.
Service centers will only accept appliances in a clean state (there should be no food residues, dust and other contamination on the appliance).