GADNIC ACALAR06 Home Alarm Wireless User Manual
- July 1, 2024
- GADNIC
Table of Contents
User
Manual
ACALAR06
ACALAR06 Home Alarm Wireless
Dual Infrared Remote Alarm
You can turn it on when going out and before going to bed, and turn it off
when returning home and getting up so that thieves have no chance to steal.
The product is very convenient to use remotely.
Detection range:
Approximately 3-4m maximum at an ambient temperature of less than 30° (avoiding remote controt with partition of walls and objects. The same type of remote control is shared).
Installation method:
It should be installed on the wall with nails and slightly tilted downward, about 1.5-2m above the floor. Or it can be placed on a table, chair or cabinet 1-1.5m high.
Method of application:
l. Turn on the alarm host with the remote control after installing the
battery, then the green light turns on for about 20 seconds. This period is
considered as the start delay time, during which you can leave the infrared
alarm detection zone.
ll. After 16 seconds, the start delay time ends and the green light turns off,
then the infrared alarm goes into alert condition.
lll. If someone enters the detection zone of the infrared alarm at this time,
the red light to the left of the green light would start flashing for 5
seconds. This 5-second delay is intended to make it easier for the owner to
turn off the alarm quickly and avoid unnecessary alarm sounds.
IV. After 5 seconds, if the product does not receive the alarm off signal from
the owner and the intruder has left the detection zone, the alarm host will
continue to emit a loud alarm sound for 30 seconds, with an alarm volume of
105dB. If someone walks back within the detection range 5 seconds after the
end of the alarm sound, the product will alarm twice in cycles.
V. When the infrared alarm emits the audible alarm, you can turn it off with
the remote control and end the alarm.
SERVICIO TECNICO OFICIAL GADNIC
www.servitech.com.ar
© 11 6260 1114 (sdlo texto)
[email protected]