CERRA12D Gadnic Electric Lock for Gates and Doors Instruction Manual
- June 1, 2024
- GADNIC
Table of Contents
CERRA12D Gadnic Electric Lock for Gates and Doors
Product Information
Product Overview
This section provides a visual representation of the electric lock set
which includes the lock body, a strike plate, two keys, an unlocking latch
mechanism, and a faceplate. The image also shows the GADNIC warranty seal.
Specifications:
- Product Name: Electrolock Right Lock 12 D
- Model: CERRA12D
- Adjustment: Spring adjustment feature
- Installation: Follow instructions and template inside the sheet
- Compatibility: Suitable for right-hand doors
- Revision: 1
Product Usage Instructions
Installation Process:
Follow the steps below to install the Electrolock Right Lock 12 D:
- Identify the door edge, door frame, center of the cylinder hole, lock, and bridge.
- Use the provided template for precise placement.
- Ensure the lock is compatible with right-hand doors.
- Securely install the lock following the provided instructions.
Spring Adjustment:
To adjust the spring, follow these steps:
- Locate the spring adjustment feature on the lock.
- Use a suitable tool to adjust the tension according to your needs.
- Test the lock after adjustment to ensure proper functionality.
Electrical Connection Instructions
Use a 10-volt power transformer with an output voltage of 8-12V DC.
Spring Adjustment
The load spring is adjustable depending on the weight of the door and the
strength of the door at the moment of closure, if applicable. The adjustment
should be made by acting on the hexagonal nut with a 12 wrench or more simply,
with pliers.
Installation Instructions
Install according to the instructions and the template inside the leaf of the door.
Electric Lock Diagram
There is a diagram illustrating the different components of the electric
lock, including the lock body and the strike plate. Additionally, a table is
provided showing the relationship between the copper cable section and the
supply distance, with measurements in mm², Ømm, and distance in meters.
Installation Diagram
The installation diagram shows the template for drilling holes in the door
and the door frame for right-side doors, with measurements provided in
millimeters. The diagram is labeled with terms such as ‘Edge of the door,’
‘Door frame,’ ‘Center of the cylinder hole,’ ‘Lock,’ and ‘Bridge.’ The minimum
recommended distance is noted, and the diagram is marked as ‘Rev.1.’
Technical Service Information
For technical support, please contact the official GADNIC technical service:
- Website: www.servitech.com.ar
- WhatsApp: 11 6260 1114 (text only)
- Email: [email protected]
Frequently Asked Questions (FAQ)
Is the Electrolock Right Lock 12 D suitable for left-hand doors?
No, this lock is designed specifically for right-hand doors.
Can the spring tension be adjusted after installation?
Yes, the spring tension can be adjusted using the provided feature. Refer to the manual for instructions.
What voltage is required for the electric lock?
The electric lock requires a 10-volt power transformer with an 8-12V DC output.
How can I adjust the load spring?
The load spring can be adjusted using a 12 wrench or pliers, based on the weight of the door and the door's strength at closure.
Is there a template provided for installation?
Yes, there is a template included for drilling holes according to the instructions provided.
Where can I find technical support?
Technical support can be accessed through the official GADNIC technical service via their website, WhatsApp, or email.