MATCO TOOLS MTCHEATJKTM Heated Jacket User Manual

MATCO TOOLS MTCHEATJKTM Heated Jacket

Product Information

Specifications

• Model Options: MTCHEATJKTM, MTCHEATJKTL, MTCHEATJKTXL, MTCHEATJKT2X, MTCHEATJKT3X
• Material: Softshell
• Type: Heated Jacket
• Model Number: 2405260-67

Product Usage Instructions

Operating Instructions

1. A: Insert the power cable into the USB port of the battery stored in the lower-left inside pocket. Fully charge the battery before first use.
2. B: Press the power bank ON/OFF switch.
3. C: Press and hold the power button on the top right chest panel for 3 seconds to preheat the jacket.
4. D: Adjust heating level by pressing the power button to cycle through temperature settings (red – high, white – medium, blue – low).
5. E: To turn off, long press the power button for 3 seconds.

Battery Specifications

• Capacity: 3.7V/10000mAh
• Input: 5V max. 2.1A (microUSB port), Output: USB 5V/2.1A, Type-C 5V/2.1A
• Dimensions: 3.6 inches x 2.6 inches x 1 inch (9 cm x 6.5 cm x 2.5 cm)
• Weight: 7.8oz/220g
• Charging Time: Approximately 5-6 hours

Cleaning Instructions

1. Disconnect and remove the battery pack before washing.
2. Cover the power cable interface with the protective cap.
3. Put the power cable into the inner pocket and zip up.

FAQ

• Q: How do I check the battery power level?
  A: Press the power button; LED lights indicate remaining battery level (LED4: 100%-76%, LED3: 75%-51%, LED2: 50%-26%, LED1: 25%-3%, Blinking LED: 3 or less).

• Q: What should I do if the jacket doesn’t start?
  A: Press the button on the side of the battery or reconnect the power cable and long press the vest’s button to turn on.

SOFTSHELL HEATED JACKET
USER MANUAL

Matco Tools Stow, Ohio 44224 www.matcotools.com 2405260-67

PACKAGE LIST

Please read these instructions carefully and operate the heated jacket as specified. Failure to follow the instructions may result in injury or product failure. If you feel uncomfortable while wearing the jacket, please remove it immediately and disconnect the power supply.
Lea atentamente estas instrucciones y utilice la chaqueta térmica según lo especificado. No seguir las instrucciones puede provocar lesiones o fallos del producto. Si se siente incómodo mientras usa la chaqueta, quítela inmediatamente y desconecte la fuente de alimentación.

OPERATING INSTRUCTIONS

• A: Insert the power cable, which is located in the lower-left inside pocket, into the USB port of the battery. The battery stores in the lower-left inside pocket. For the first use, please fully charge the battery. If you want to check the battery level, press the button on the side of the battery to view the charge level. For more details, please review the “Battery Instructions” portion of the instruction manual.
• B: Press the power bank ON/OFF switch.
• C: Press and hold the power button on the top right chest panel for (3) seconds. The button will light up and the jacket will begin to preheat.
• D: The heating level can be adjusted by briefly pressing the power button on the jacket. Each press will cycle through the jacket’s temperature setting from red light (high temperature) to white light (medium temperature) to blue light (low temperature).
• E: To turn off, long press the power button of the jacket for (3) seconds until the light turns off.

BATTERY SPECIFICATIONS

BATTERY INSTRUCTIONS

• A: Use USB to charge mobile devices.
• B: Use the USB power cable, located in the lower-right inside pocket to power the jacket.
• C: Use the Micro-USB to charge battery.
• D: Use Type-C to charge battery or other type-C devices.

CHECKING BATTERY POWER

When you press the power button, the LED on the side that indicates the remaining battery level will light up, allowing you to check the remaining battery level.

Note:
If the heated jacket does not start, press the button on the side of the battery or reconnect the power cable and long press the button of the vest to turn on.

BATTERY USE

CLEANING INSTRUCTIONS

1. Before washing the vest; Disconnect and remove the battery pack from the inner pocket, cover the power cable interface with the protective cap, and put the power cable into the inner pocket and zip up.
2. Hand wash or machine wash gently in cold water.
3. Do not use bleach or other corrosive liquids.
4. Line dry. Do not iron, dry clean, or tumble dry.

BATTERY RECYCLING

• This product has a built-in lithium-ion battery.
• Used lithium-ion batteries are a valuable resource.
• The batteries can be reused. Instead of throwing them away, cover the output and input terminals with tape, etc., and then bring them to a business that recycles rechargeable batteries.

SAFETY INSTRUCTIONS

This jacket is to be used by adults only. If you have any questions about your health and the use of a heated jacket, please contact a licensed physician.

• Never use if lining is wet.
• Heating elements should not have contact directly with your skin.
• Shut off power supply immediately if discomfort occurs.
• Do not allow the cords to be pinched, may cause damage and fraying.
• Do not use pins. It may damage electrical wiring.
• Disconnect and remove battery pack from inner pocket before washing.
• Do not dry clean or use dry cleaning fluid on this vest . Do not bleach. Cleaning solvents may have a deteriorating effect on the insulation of the heating elements.
• Machine wash or hand wash and line dry. Do not iron, ring dry, dry clean, or tumble dry.
• Do NOT store the battery pack together with metal objects (short circuit risk).
• Never disassemble the battery packs and chargers, only store in dry rooms. Keep dry at all times.
• Dispose of used battery packs according to your local regulations.
• Battery acid may leak from damaged batteries under extreme load or extreme temperatures. If you come in contact with battery acid, wash it off immediately with soap and water.
• If battery acid gets in contact with your eyes, rinse thoroughly for at least 10 minutes and immediately seek medical attention.
• If the battery malfunctions, please stop using it immediately.
• Please use in an environment between 41°f – 86°f (5°c – 30°c). Charging at other temperatures will not allow the product to achieve its full performance and may also cause heat generation and malfunctions.
• Do not place heavy objects on it, or place it in places where it can easily fall, be magnetic, or have a lot of dust. Doing so may cause heat generation, fire, or malfunction.
• This product is made of metal parts and plastic. It is dangerous to burn it, so please dispose of it correctly according to the instructions of each local government.
• When not in use, be sure to turn off the power and disconnect cables from all connections.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>