GLETON GLF2419-1 Pull Out Faucet Instruction Manual
- June 28, 2024
- GLETON
Table of Contents
GLETON GLF2419-1 Pull Out Faucet
Please install correctly according to the contents of this instruction manual.
Condition for use
- a Water pressure range for hot/cold water Min 0.05MPa-Max 0.75MPa.
- b. Water temperature 70°C, Do Not use steam for hot water
- c. It might deform or crack due to freezing when the ambient temperature is under O’C, so please use it above 0°C
Maintenance and Use Precautions
- a. Please use the faucet in a gentle way for long-term durability
- b. Please unscrew and clean the aerator when the spout is blocked.
- c. Do Not use nylon or detergent like cleanser and polishing powder that contains coarse particles to do the cleaning.
- d. Do Not use any acid detergent to avoid corroding the plating, please wash well the ceramic around the product when cleaning with acid detergent.
- e. Please use a cloth dipped in a neutral detergent diluted properly to do the cleaning when the product is dirty and then wipe it clean with a dry soft cloth.
- f. The plating surface of the product will be tarnished when it’s attached with any cosmetic or detergent, please wash wel I and wipe it with a dry soft cloth.
- g. Please take necessary warming measures to your household water supply equipment when it’s under 0°C. Do Not use the switch handle when the product is frozen, unfreeze it with hot water before you use it
- h. Free replacement or compensation will not apply for any product damage property loss and body inquiry due to non-compliance to the instruction terms
Instruction for Use
- Water flow rate adjustment
- Turn the handle toward left. water flow rate increases.
- Turn the handle toward the faucet, water flow decreases.
- Water temperature adjustment.
- Turn the handle frontward for hot water
Turn the handle backward for cold water
Installation Instruction
-
Make sure to clean the pipes to avoid blocking before installation
-
Please note that the hole for installation must be (j)35mm. See the illustration on the right.
-
Make sure to clean the dirt around the hole before installation,
-
Be cautious to protect the product surface from scratching during unpacking and installation. Do Not twist the product with pipe wrench with full force.
-
Shut off the water supply. Remove the old faucet. Clean the mounting surface. Thread the faucet through the hole and install it on the countertop.
-
Install the mounting hardwares (B-E) in sequence according to the figure below, and fix the faucet on the countertop.
-
Assemble the digital display component according to the figure below.
-
Assemble the gravity hammer to the pull cord as shown in the figure below Its height is preferably one-third of the height of the end.
-
Connect the hot and cold water pipes to the water suppliers separately, please pay attention to distinguish the hot and cold water suppliers.
-
Turn on angle stops, turn the faucet on and check for leaks.
(DO NOT TURN FAUCET ON BEFORE THE INSTALLATION IS COMPLETE)
More Details on www.gleton.com
Documents / Resources
|
GLETON GLF2419-1 Pull Out
Faucet
[pdf] Instruction Manual
GLF2419-1 Pull Out Faucet, GLF2419-1, Pull Out Faucet, Out Faucet, Faucet
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>