KOSO WH030GA01A Zenith LED Headlight Instructions
- June 27, 2024
- KOSO
Table of Contents
KOSO WH030GA01A Zenith LED Headlight
Specifications
- Size: 92 mm x 35 mm x 111 mm
- Weight: 35 mm x 35 mm
- Mounting Screws: M3xP0.5xL8 mm, M6xP1.0xL10 mm, M8xP1.25xL11 mm
- Dimensions: 61 mm x 31 mm x 75.5 mm
- Standard: JIS D 0203
- Homologation: E-Mark / DOT Approved
- Effective voltage:
- Front position: DC 12V / 2.7W
- Low beam: DC 12V / 24.9W
- High beam: DC 12V / 20.2W
Product Usage Instructions
Installation Precautions
Before installing the product, please read the instructions carefully and
follow the steps described to avoid any damage.
- Avoid short circuits by not pulling or modifying the wires during installation.
- Do not disassemble or change any parts as it may void the warranty.
- Maintenance and repairs should be done by professionals only.
Wiring Installation
Follow these instructions for wiring the headlight:
- Yellow wire: Low beam light
- Blue wire: High beam light
- Black wire: Ground (-) – Connect to the vehicle body or engine for a good ground.
- White wire: Front Position Light
Troubleshooting
If you encounter issues, follow these steps before seeking repairs:
- If LED indicator is not lighting up:
- Check power supply cable for disconnection or damage.
- Ensure positive and negative poles are connected properly.
FAQ
- Q: What should I do if I encounter problems that I cannot solve?
A: If the issues persist, contact our technical department for assistance.
Thank you for purchasing our product. Before installing/operating the product, read the instructions carefully and retain them for future reference.\
Attention!
- For installation, follow the steps described. Any damage caused by wrong installation shall be imputed to the users.
- To avoid a short circuit from occuring do not pull or modify the wires during installation.
- Do not disassemble or change any parts. Opening and dissassembling this unit will void any warranty.
- Maintenance and repairs should be executed by our professionals only.
NOTE
- Some procedures must be followed to avoid damages to the instrument.
- WARNING! Certain procedures must be followed to avoid damages to yourself, to the vehicle or to others.
ACCESSORIES
SPECIFICATIONS
NOTE Design and specifications are subject to change without notice.
WIRING INSTALLATION INSTRUCTIONS
TROUBLESHOOTING
The following situation do not indicate malfunction of the meter. Check the following before taking it in for repair.
| Trouble | Check item |
|---|---|
| No LED indicator lighting up. |
- Power supply cable may be disconnected.
- Check if power supply cable is broken or disconnected.
- Check if positive and negative poles are properly connected.
If the problems still cannot be solved, contact our technical department for assistance.