Maisto M81483 2.4Ghz Stunt Flyers User Manual

Maisto M81483 2.4Ghz Stunt Flyers

Age 8 +

Warning! Not suitable for children under 36 months.Small parts. Choking hazard.
Please keep this owner’s instruction manual for future reference. It contains important information.
We reserve the right to improve/revise the product specifications without notice.
Toy must be assembled under adult supervision.
This toy is only to be connected to equipment bearing the symbol .

Class 1 LED product

Contents:

• Plane x 1
• Transmitter x 1
• USB Cable X 1
• Spare propeller x 1
• Label sheet X 1
• Instruction Manual x 1

Battery requirement:
Plane: 1 x 3.7V Li-poly Rechargeable Battery Pack (built-in, non- replaceable).
Transmitter: 2 × 1.5V “AAA” LR03/R03 Batteries.

Install the Plane and stick the label in the right position before playing

Battery installation for the controller: (Refer to Diagram 1)

1. Switch the power OFF.
2. Use screwdriver to loosen the screw on the battery cover and to open the battery cover. (Screwdriver is not included)
3. Install 2 new 1.5V “AAA” LR03/R03 batteries with correct polarity (+/-) as shown inside the battery compartment.
4. Install the battery cover and then tighten the screw on the battery cover

Charging The Plane: (Refer to Diagram 2)

1. Make sure the switch is on the OFF position before charging.
2. Locate a USB certified port from any of the devices shown here.
3. Connect the USB charging plug with the USB certified port.
4. The LED indicator will start lighting in red to show it is charging.
5. Once the LED indicator turns off, the plane is fully charged.
6. Detach the USB plug from the USB certified port.

How to play: (Refer to Diagram 3, 4, 5, 6 & 8)

1. Set the “Power Switch” on the controller and plane to the ON position, the “Power LED” on both the controller and plane will flash for less than 3 seconds and then stay on, meaning the automatic frequency matching between the controller and the plane is completed.
2. If the “Power LED” of the controller or the “Power LED” of the plane flashes more than 3 seconds, switch off both the plane and controller, then turn them on again.
3. Pull the trigger in the transmitter full way to obtain extra speed then throw the plane out up to 20° to fly in anticlockwise. Continue pull and release the trigger to control the plane fly up and down. (Refer to Diagram 4)|
4. After the battery is fully charged, the plane is able to play around 5 minutes.
5. Turn the switch of the controller and plane to the OFF position when not in play.
6. Follow Diagram 5 to replace the new propeller.
7. After playing, place the plane properly to avoid distortion that will affect the flying. (Refer to Diagram 6)
8. Do not place anything on the plane when not in play, it will cause to damage the plane.
9. If plane fuselage becomes deformed affecting performance, bend the fuselage by hand, up and down, or in opposite direction to adjust and correct this issue.(Refer to Diagram 8)

Environment For Flight
Choose the following conditions:

1. Make sure to be in a large space with an open radius of at least 10 feet.
2. For best performance, it is recommended that you operate the Plane in zero or low wind conditions. Wind can greatly affect the performance of the Stunt Plane.

Cautions:

1. The Built-in rechargeable battery must be charged before use.
2. Do not overcharge the Battery.
3. Do not charge the Battery if it shows leakage, corrosion, or has loose or exposed wires or other damage.
4. Do not cover the plane with any sort of material while charging.
5. Do not touch the plane when it is hot. Wait until the plane cools before recharging.
6. Do not dispose of the Battery in fire.
7. Do not dismantle the Battery or USB, and do not cut the Battery or USB cables.
8. The USB Cable used with the toy shall be regularly examined for damage to the cord, plug, enclosure and other parts, and in the event of such damage, they must not be used until the damage has been repaired.
9. Rechargeable batteries are to be removed from the toy before being charged (for transmitter).
10. The Battery will be warm after charging, and hot after use in a plane
11. The supply terminals are not to be short-circuited.
12. Rechargeable batteries are only to be charged by adults or by children at least 8 years old.
13. Battery change must only be made by adults!
14. Note that the 1.5V “AAA” Battery is non-rechargeable and is not to be recharged. Only Batteries of the same or equivalent type as recommended are to be used. It will need replacement when transmission is poor. Alkaline AAA batteries are recommended to be used for the transmitter. Do not mix alkaline,standard or rechargeable batteries. Do not mix old and new batteries or different type of batteries. Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions.
15. Exhausted batteries must be removed from the product.
16. Do not attempt to disassemble the products.
17. The toy shall be used with caution since skill is required in order to control the flight and avoid collisions with\ the user, objects or third patties.
18. Do not touch the rotating rotor, avoid loose clothing or hair that could be caught in the rotor, do not fly near the face. (Refer to Diagram 7)
19. Adult supervisors should teach children how to safely fly and control the toy.
20. Remove the package, take out all accessories and assemble the product before giving it to children to play.

FCC Label Compliance Statement:

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions :

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

RSS-210 Compliance Statemetent:
This device contains licence-exempt transmitters)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).

Operation is subject to the following two conditions:

1. This device may not cause interference;
2. This device must accept any interference, including interference that may cause undesired operation of the device.

Troubleshooting

Environmental notes:

• The whole product also does not belong to household waste at the end of the product life.
• You can return it at collection points for the recycling of electronic and electronical instruments.
• The symbol on the item, instruction manual, hangtag or packing is showing this clearly.
• Materials should be recycled according to their respective markings.
• Recycling of old devices or other re-use of materials contained therein represents an important contribution to environmental protection.
• Please ask at your local community for the correct collection point.
• Please retain this sheet and address for future use, as they contain important information.

Disposal of batteries

• Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return batteries containing harmful substances and all other used batteries.
• You can hand in your old batteries at public collection points in your area or wherever batteries are sold.
• You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances:
  • Pb = Battery contains lead
  • Cd = Battery contains cadmium
  • Hg = Battery contains mercury
  • CE Declaration

Hereby, MAY CHEONG GROUP FRANCE S.A.S., declares that this equipment is in compliance with the essential requirements and other relevant provisions of directive 2014/53/EU.

Frequency: 2.4GHz
Transmitting frequency band: 2.4-2.4835GHz
Max allowed transmitting power: <10mW

The declaration of conformity may be consult at:
MAY CHEONG GROUP FRANCE S.A.S.,
Parc Ariane – Le Vénus, 2 rue Hélène Boucher, 78280 Guyancourt, France.

The full text of the EU declaration of conformity is available at the following internet address: www.maycheonggroup.com.hk/declaration-of- conformity

www.maisto.com

MADE IN CHINA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>