Te-Rich JN01 Wake Up Light User Manual

Te-Rich JN01 Wake Up Light

IMPORTANT SAFETY INFORMATION

Danger

• Water and electricity are a dangerous combination. Do not use this appliance in wet surroundings (e.g. in the bathroom or near a shower or swimming pool).

• Keep the adapter dry.

• Do not let water run into the appliance or spill water onto the appliance.

• This appliance is for indoor use only.

Warning

• If the adapter, cord or appliance has been damaged in any way, lliquid has spilled or objects have fallen into and/or onto the appliance, the appliance has been exposed to rain or moisture, does not operate normally or has been dropped or damaged, it should not be operated.
• Only use the appliance in combination with the adapter supplied.
• If the adapter (cord) is damaged, always have it replaced with one of the original type in order to avoid a hazard.

Caution

• The appliance has no on/off switch. To disconnect the appliance, remove the adapter from the wall socket. The adapter must remain easily accessible at all times.
• If you often wake up too early or with a headache, reduce the set light intensity level and/or the set Sunrise Simulation time.
• If you often wake up by the alarm sound, increase the set light intensity level or the set Sunrise Simulation time.

‘What’s in the box

1. User Manual
2. Power Cord
3. Wake-Up Light
4. SV /2A adapter

The Effects of Wake-Up Light

The Wake-Up Light gently prepares your body for waking up during the last 10 to 60 minutes, depending on the Sunrise Simulation time you set. In the early morning hours our eyes are more sensitive to light than when we are awake. During that period the relatively low light levels of a simulated natural sunrise prepare our body.
If the Sunrise Simulation is active (default is 30 minutes), the light intensity of the lamp gradually increases to the set level and the light color changes from deep morning red to bright daylight. The light gently prepares your body for waking up at the set time. To make waking up an even more pleasant experience, you can use natural wake-up sounds or the FM radio to wake up to.

Overview

NOTE: All your personalized settings will be permanently stored in the memory, they not be erased by removing the adapter fromwill the electrical outlet. You can change all settings at any time, the last setting will be stored.

Display icons

NOTE:
The Wake-Up Light comes with a pre-installed CR2032 battery. When the Wake-Up Light is not plugged in, the attached battery stays memory mode. Normally, the battery lasts 3 years.

Power on

Please use a 5V/2A adapter to connect the Wake-Up Light and power on. Some functions will be limited if the adapter power is less than 5V/2A.
Place the Wake-up Light 16-20in/40-50cm from your head, for example on a bedside table.

Setting the clock time
You have to set the clock time when you plug in the appliance for the first time.
Press and hold the button on the right to enter the time-setting process. The operation steps are as follows:

1. CD Press the button to adjust it to 12-hour or 24-hour format. And Press the c button to confirm, then next;

2. Press the button to set Hours;
   And press the button to confirm, then next;

3. Press the button to set Minutes;
   And press the cl button to complete.

Searching for FM channels

Both the Fall-asleep and FM Radio are based on FM channels. Please search FM channels first.
Tip: Make sure to unwind the antenna fully and move it around until you receive the best reception.

1. Pressa button to turn on the FM radio.
   Press for 2 seconds to automatically search for channels (frequency from 76.0MHz to10 8MHz). USER TIP: After searching for FM channels for the first time, you can step into the previous channel directly just by clicking the llEJ button.
   Listening to the Radio

2. Press ****button to turn on the FM radio.

   • Adjust the channels manually 25 A

3. Press and hold  button to adjust channels manually after automatic channel searching

• FM Volume
  When FM is enabled, click to adjust the radio volume. The volume ranges from 01 to 20.

• Press ****button again to turn off radio.

Using sunrise light as a lamp

1.  Press button to turn on the Sunrise light.

   • Light Brightness
   • Use the button to adjust the light brightness while it is lightening.The brightness ranges from 01 to 20.
   • Press button again to turn off sunrise light.
     Colored lights|
     

2. Press the button to turn on the colored lights.

• Adjust the lighting mode:
  Press button repeatedly to adjust the colored lights in turn. There are 11 lighting effects.
  1~5: Color-Mode(Red, Green, Cyan, Blue, Purple); 6~11: Effect- Mode(autochromic, clockwise, counterclockwise, aurora, flame, Snowy mountain).

• Light Brightness
  Use the button to adjust the light brightness while it is lightening.The brightness ranges from 01 to 20.

• Press button again to turn off the colored light When you adjust it to C-11 mode.

Fall-asleep

Sleep sound options

1. Press and hold ( utton on the right to enter sleep sound setting process. The following steps are completed by

2.  The word “S-Ox” will flash on the screen. Use the button to choose among the following 7 options: S-01 ~ S-07 (Built-in White Noise); FM Radio (The channel of the Radio depends on the channel you listened to last time).
   Press the button to complete.

   • Sleep timer
     Press the button repeatedly to adjust the duration of the sleep timer. Options available are 15/30/60/90/120/180 minutes, OFF. The setting will automatically be saved and start after 2 seconds.

   • Sound volume
     Press to adjust the sound volume while it is sounding (level 1 to 20).

   • The operation after sleep started
     You can continue to adjust the sleep sound parameters and light mode. And the volume and light brightness will fade until the timer is ended.

3. You can continue to adjust FM <ad;o, See page 8 for details.

4. You can continue to adjust the i light, See page 9 for details. :

Setting alarms(Alarm 1)

Press and hold the button on the left to enter the Alarm1 setting process. The following steps are completed by
When you set your alarm, you set the alarm time (steps 1 2 the alarm sounds (steps3 4 and the sunrise profiles (steps5 6) you want to wake up to.

1. Press the button to set Alarm-hours;
   And press the ( button to confirm, then next;

2. Press the button to set Alarm-Minutes;
   And press the button to confirm, then next;

3. Press the to set alarm-sounds;
   And press the button to confirm, then next;
   The range is: OFF:
   No Sound; S01~507 : Wake-Up ringtones(Beep, Ocean, Valley Echo, Doorbell, Guitar, Piano, Message); FM Radio(The channel that the Radio wakes up depends on the channel you listened to last time).

4. Press the button to adjust Alarm Volume; And press the button to confirm, then next (Volume level 01 to 20);

5. Press the button to set sunrise time in advance; And press button to confirm, then next;

6. The range is: OFF: Sunrise off Sunrise minutes before the alarm goes off.

7. Press the button to set maximum brightness of Sunrise, And press the button to complete(Sunrise level 01 to 20).

NOTE(Alarm 2):
Alarm 2 works in the same way as alarm 1.

Snoozing

When the wake-up curve has ended (when the set maximum light intensity has been reached) and the alarm sound is playing, you can tap the top button to snooze. The lamp stays on, but the sound is muted. After 9 minutes, the alarm sound starts playing again.

Turning the alarm off

When the alarm goes off, you can turn it off by pressing the button. If you turn off the alarm, the alarm profile is deactivated for that day.
Note: The light and sound automatically turn off 30 minutes after the I arm has gone off.

Alarm on/off I Alarm set

• Press ****button if you want to switch the alarm on or off. The corresponding icon appears on the display when you switch on the alarm. It disappears when you switch off the alarm.
• Press and hold ****button to enter alarm setting process. See page 11 for more details.

Colored lights
See page 9 for more details.

Snooze / Sunrise light

• When the alarm sound is playing, you can tap the top( )button to snooze.
• Press button to turn on the Sunrise lig1ht.

FM radio
See page 8 for more details.

Fall-asleep

See page 10 fair more details.

Dimmer/ Time set

• In the time display interface, click the ****button to adjust the brightness of the screen to 100%-75%-25%-OFF in turns.
• Press and hold ****button to enter time setting process. See page 7 for more details.

Bluetooth Speaker

1. Press and hold the button, and the BT icon on the screen will start flashing.
2. Open the Bluetooth settings on your phone, find the device named “Sunrise Speaker,” and click to connect.
3. When the BT icon on the screen stays on, the device is successfully connected, and you can use your phone’s player to play music.

• Press and hold the button again to turn off the Bluetooth speaker.
• Click to adjust the volume when you playing music (volume levels range from 01 to 20).

 Charging your USB device

You can use the USB port to charge your USB device (max 1000 mA).

Cleaning and storage

• Clean the appliance with a soft cloth.
• If you are not going to use the appliance for an extended period of time, remove the adapter from the wall socket and store the appliance in a safe, dry location where it will not be crushed, banged, or subject to damage.
• Do not throw away the product with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment.
• Follow your country’s rules for the separate collection of electrical and electronic products. Correct disposal helps prevent negative consequences for the environment and human health.

Specifications

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>