zafferano LD1840 Olivia Micro Pro LED Battery Light Instruction Manual

June 25, 2024
zafferano

zafferano LD1840 Olivia Micro Pro LED Battery Light Instruction Manual

INSTRUCTIONS FOR USE

TECHNICAL DATA

LED TOUCH DIMMER | 2,2 W | 183 – 187 – 225 lm | 2200 – 2700 – 3000K | IP65 | CRI>80 | 5Vdc max. 1A
Symbols

Dimension

Dimension

This product contains a Class G light source.

Lifespan/Recharging
Battery lasts about 9 H. h at full power.
Charging time at 1A : 4,5 h.

Accessories/Spare parts
Included : contact charging base;
Not included: battery charger with USB input; multi-contact charging base (max. 12 pc); multi-socket USB charger (8xUSB); replacement battery pack; replacement LED board.

Switching On / Switching Off / Dimmer function

Tap the quick touch sensor a few times to switch the device on and off.
When the lamp is switched on, gently tap the touch sensor to obtain the desired brightness. Every time it is switched on, the light intensity will correspond to the previously set intensity.
Dimmer function

Colour temperature configuration

  1. When the lamp is switched off, gently press for 4 seconds until a constant blue LED lights up.

  2. Tap the quick touch sensor to change the colour temperature of the lamp.
    Colour temperature configuration

  3. Gently press for 4 seconds to memorise the new colour temperature and switch off the lamp.

Indicator LEDs

  1. Permanent red LED: recharging in progress.

  2. Permanent green LED : the battery is 100% charged, disconnection from the power charger is recommended.
    Important: fully charge the battery before using it for the first time.

To charge the lamp correctly, it is advisable to:
a. Connect the USB cable to a charger;
b. Connect the plug to the electrical socket;
c. Place the lamp on the charging base;
d. When recharging is over, disconnect the plug from the mains socket and remove the USB cable.

INCLUDED ACCESSORIES

LD1840RB
INPUT: 5Vdc max 1A
OUTPUT: 5Vdc max 1A

Single-contact charging station.

NOT INCLUDED ACCESSORIES

LDO870RP
45 W
INPUT: AC100-240V 50/60Hz
OUTPUT: 9Vdc max 5A (6 pcs.)
Symbols
Multi-contact charging base (max. 6 pc).

LDO340RA
40 W
INPUT: AC100-240V 50/60Hz
OUTPUT: 5Vdc max 8A
Symbols
Multi-socket USB charger (8xUSB).

SPARE PARTS

Replacement battery pack
Scan the QR code to see how to replace the exhausted batteries of your lamp.

Replacement LED board
Scan the QR code to see how to replace the LED board of your lamp.

LDO490UA
INPUT: AC100-240V 50/60Hz
OUTPUT: 5Vdc max 1A

Battery charger with USB input

WARNINGS
This product is exclusively for lighting purposes and:
A) It must not be exposed to heavy mechanical loads or severe contamination;
B) It can only be installed and used after checking the condition of the product; check that it is not dirty and has not been damaged during storage;
C) Installation and maintenance must be carried out when the appliance is switched off;
D) Any alteration or tampering with the product and any non-compliance with the instructions given may make the device unsafe;
E) When fully assembled, the lamp (top+structure, without the charging base), reaches an IP≥54 rating, making it ideal for outdoor use; The light fixture (top) alone and the assembled lamp placed on the charging base has an IP20 rating, making it unsuitable for outdoor use;
F) To clean all metal and plastic surfaces, use a soft, dry cloth and a neutral detergent for more stubborn dirt;
G) The company Sufferance accepts no liability for damage caused by its own product not being assembled in accordance with the instructions;
H) The versions with a metal leaf finish, handmade and protected by a clear varnish, and those with a galvanic finish are more delicate. We recommend cleaning using only a soft, dry cloth. The use of aggressive cleaning agents or abrasive cloths, and any accidental knocks and rubbing may damage the delicate leaf finish.
I) The supporting surface of the lamp must not tilt more than 15° or it may fall.
J) We recommend using the original optional charger and cable; alternatively, you can use a certified max. 1A charger;
K) The lamp works correctly also when connected to the mains power supply;
L) The battery has an overload protection function;
M) To preserve the integrity of the battery, we recommend keeping the charge between min. 20% and max. 80%. If the lamp is not used for long periods, it is advisable to regularly charge/discharge the product;
N) Please refer to local legal regulations for the proper disposal and recycling of the battery.

LEGEND

Declares that the product meets  EU standards for health, safety, and environmental protection

Apparatus based on a safety extra-low voltage supply, in which voltages above the same are not produced

Appliance equipped with double insulation and/or insulation reinforced in each part and without grounding device.

Indicates that the light intensity of the lamp can be adjusted.

IP20: equipment protected from the penetration of solids larger than 12mm and not protected from liquids.
IP54 : apparatus protected from dust and splashing water.
IP65: luminary strongly protected from dust and water jets.

Demonstrates that your products meet the Eurasian Economic Union (EAEU)’s regulations and standards for customs clearance and trading.

  • User-replaceable LED source

  • User-replaceable driver

  • User-replaceable battery

  • LED source replaceable by qualified personnel

  • Driver replaceable by qualified personnel

  • Battery replaceable by qualified personnel

  • Non-replaceable LED source

  • Non-replaceable driver

  • Non-replaceable battery

  • User-replaceable source

  • User replaceable light source

For more information and updates visit our website
www.zafferanoitalia.com
QR Code

Light Department
+39 0422 470 507
lighting@zafferanoitalia.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

zafferano User Manuals

Related Manuals