TERMA ONE Dual Fuel Radiator Instruction Manual

ONE – Dual Fuel Radiator

1. Choose the option of installation that fits to you best.

2. Slide on masking cover.

3. Install and tighten the heating element by hand only.

4. Fill the radiator with the water, then bleed it. Once bled make sure that at least one valve remains open.
   NEVER OPERATE THE HEATING ELEMENT WITH BOTH VALVES CLOSED.

5. Connect the heating element to the power supply.

6. Your radiator is ready.

HINT: Do not turn on the heating element and your central heating at the same time.

ONE – Electric only Radiator

1. Correct position of the radiator and heating element.
2. Slide on masking cover.
3. Install and tighten the heating element by hand only.
4. Fill the radiator with a proper heating agent. (Read the section “Before installation” page ….)
5. Fit the radiator to the wall and connect the heating element to the power supply.
6. Set the heater on max and keep it for 30min (the plug opening must be open).
7. Check the level of the hot heating agent inside the radiator, add more if needed.
8. Close the radiator plug. Your radiator is ready.

FOR USERS IN UK ONLY
ONE – Dual Fuel Radiator

1. Choose the option of installation that fits to you best.

2. Slide on masking cover.

3. Fit the Tfitting to the radiator (if needed) and then install the heating element. Install and tighten by hand only.

4. Fill the radiator with the water, then bleed it. Once bled make sure that at least one valve re- mains open.
   NEVER OPERATE THE HEATING ELEMENT WITH BOTH VALVES CLOSED.

5. Connect the heating element to the power supply.

6. Your radiator is ready. HINT: Do not turn on the heating element and your central heating at the same time.

MEG-MOA-SOA-SEC-REG – Dual Fuel Radiator

1. Choose the option of installation that fits to you best.

2. Fit the T-fitting to the radiator (if needed) and then install the heating element. Tighten it using the correct spanner (size 22).

3. Fill the radiator with the water, then bleed it. Once bled make sure that at least one valve re- mains open.
   NEVER OPERATE THE HEATING ELEMENT WITH BOTH VALVES CLOSED.

4. Connect the heating element to the power supply.

5. Your radiator is ready.

HINT: Do not turn on the heating element and your central heating at the same time.

MEG-MOA-SOA-SEC-REG – Electric only Radiator

1. Correct position of the radiator and heating element.
2. Install and tighten the heating element using the correct spanner (size 22).
3. Fill the radiator with a proper heating agent. (Read the section “Before installation” page ……)
4. Fit the radiator to the wall and connect the heating element to the power supply.
5. Set the heater on max and keep it for 30min (the plug opening must be open).
6. Check the level of the hot heating agent inside the radiator, add more if needed.
7. Close the radiator plug. Your radiator is ready.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>