KEY DIGITAL APP READY Source and Display Control 4K AV Over IP + Key Digital App User Manual
- June 3, 2024
- KEY DIGITAL APP READY
Table of Contents
READY Source and Display Control 4K AV Over IP + Key
Digital App
User Manual
4K AV over IP Tech Guide
KD App Source & Display Control Feature
Key Digital Source & Display Control feature for 4K AV over IP systems
controlled by the Key Digital iOS App, enables IR control of popular HDMI
source and Display evices without any control system or programming.
System Requirements
Source & Display may be configured in any Key Digital 4K AV over IP Systems on
KD-IP822ENC, KD-IP822DEC, KDIP922ENC, KD-IP922DEC, KD-IP1022ENC, and KD-
IP1022DEC units with firmware v1.56
Supported Devices
Sources | Displays |
---|---|
DirecTV H/HR | LG |
Dish Network VIP | Samsung |
Comcast Xfinity | Sony |
Cisco HD Explorer | Vizio |
Arris DCX | Epson PowerLite 2181788 |
Motorola QIP | Panasonic |
SkyQ | Philips Pro |
AppleTV | Sharp |
Roku |
Setup
Use the latest Key Digital Management Software
Pro
to configure Source Control in Encoders or Display Control in Decoders. Use
the dropdown menu to choose your supported device.
4 K AV over IP Tech Guide
Wiring
Use I/O port 1. Connect the striped wire (IR signal) to pin 1. Connect the
solid wire (ground)to pin 2.
If controlling a video wall, all IR emitters for the video wall displays MUST
connect into VideoWall Decoder ID 1 (AKA top-left display). This is necessary
because the KD App uses Decoder1 as the control interface for the video wall.
Control
Open the KD App, scan your network, and choose your system to enter the
control UI.
Upon selecting Displays (decoders) and Sources (encoders) with Source &
Display control enabled, press the desired buttons in the respective control
panels at bottom-left and bottom-right of the screen.
You may toggle between the main directional control pad and numerical
keypad in the Source Control panel by pressing the numerical button icon: