euromex Delphi-X Inverso Microscope User Manual
- June 22, 2024
- euromex
Table of Contents
quick start manual for use of DIC User Manual
additional
v.425271
Quickstart
Preface
The Delphi-X Inverso has been designed for easy use of DIC imaging. The
following steps will quickly guide you through the set-up process of the
microscope
To work properly the setup of the DIC system needs a combination objective,
condenser prisms, rotatable analyzer and the objective DIC prisms
The DIC prisms for objective and objectives work in specific pairs. Therefore,
the DIC prism sliders are marked with the magnification of the matching
objective
DIC prisms for condenser
The DIC prisms are already pre-mounted n the factory, there is no need to
adjust anything Setting up
- Insert the objective prisms into the slots of the condenser positioned under the objective. The DIC prism sliders are marked with the magnification of the matching objective (photo 1)
- Insert the rotatable analyzer into its slot (photo 2)
- Set the condenser position to BF (photo 3)
- Focus on your specimen (start with lowest magnification)
- Rotate the analyzer till the image turns dark
- Set the condenser position to DIC or DICII (photo 4)
- Fine-tune the DIC image by rotate the analyzer
Phase contrast, fluorescence and brightfield microscopy
Remove the DIC objective prism, rotatable analyzer, change the condenser
position from DIC or DICII to brightfield or phase contrast. before starting
microscopy. Doing so will increase the brightness of the image and overall
image quality
euromex.academy
All information mbaye changed with . out pnor notice v.425271
Documents / Resources
|
euromex Delphi-X Inverso
Microscope
[pdf] User Manual
DIC_manual_EN_2, Delphi-X Inverso Microscope, Delphi-X, Inverso Microscope,
Microscope
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>