GAMEON SPY2 ATX 850 Watts 80 Plus Bronze Value Gaming Power Supply User Manual
- June 21, 2024
- GAMEON
Table of Contents
GAMEON SPY2 ATX 850 Watts 80 Plus Bronze Value Gaming Power Supply User Manual
CONTACT US
HEY@GAMEON.STORE
WWW.GAMEON.STORE
Warnings and Safety Instructions
- Please read all sections of this manual carefully before using the device for the first time.
- Do not open the top cover of the power supply. The on-board electronic components generate high-voltages which are hazardous. A power supply should be opened only by an authorised engineer.
- If you do open the power supply the seal will be damaged, this will void the warranty.
- Never handle the power supply with wet hands
- Never insert objects into the holes/fan of the power supply
- Note that this power supply is designed for use indoors only. Using the device outdoors can cause serious damage to the power supply
- Do not handle the power supply while it is connected to a power socket
- Make sure your PC is not near a heater or any ther heat source. This could reduce the lifetime of the power supply and may lead to failures
- Make sure your computer case has adequate ventilation. Maximise cooling through additional fans, otherwise the power supply will evacuate the total heat produced in the PC case and this will also shorten the lifetime of power supply
- If you want to clean your power supply, remove it completely from the mains and do not use wet rags or detergents, clean the power supply only with a dry cloth or vacuum cleaner
Model Descriptions
GO-SPYATX850W
Specifications
Type: Intel ATX 12V V2.31/EPS 12V V2.92
Input voltage: 220V
Input frequency range:47Hz-60Hz
Fan: super silent 12cm or 14cm
Power good signal:100-500ms
Hold up time: > 17ms
MTBF: >100,000 Hours
Protection: OVP/UVP/OPP/OTP/SCP
Dimension: 160 x 150 x 85mm
Operation temperature: 0-40°C (Nominal input voltage)
Connector Descriptions
Installation Instructions
Please read the “Warning and safety instructions” before operation. Please mount the power supply as following:
- Mount the power supply to the PC case with screws
- Connect the 24pins cable to the motherboard. For more details, please see the instructions of the motherboard. Make sure that you connect to 20pins cable combined with the 4pins cable (total 24 pins)
- If the motherboard only has 20pin connector, please connect the 20pins cable to the motherboard
- Next, connect the 4pin connector (12v for CPU, not the 4pins connector beside the 20pins connector) to the motherboard (some old motherboards don’t need this connector)
- When your motherboard has two CPUs installed. Please connect another 4pins connector to the motherboard
Please see the manual of the motherboard for more information. Not all motherboards provide 4+4pins connectors for double CPUs
Connection of internal components
- Connect your internal components such as CD, DVD, hard disk, graphic card with their corresponding cable
- Please refer to the instructions of those components before installation
- Before connecting the power cord of the power supply, check those cables again to make sure they are connected safely and correctly
WEEE Notice
Disposal of Waste Electrical and Electronic Equipment by users in private households within the European Union.
The WEEE symbol on the product or on its packaging indicates that this product must not be disposed of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of Waste Electrical and Electronic Equipment. The separate collection and recycling of your waste equipment at the time of disposal will help to conserve natural resources and ensure the product is recycled in a manner that protects human health and the environment. For more information about where you can drop off your waste equipment for recycling, please contact your local council, your household waste disposal service or the shop where you purchased the product.
Warranty
We guarantees this device to be free of defects in material and workmanship, and provides a 2-year hardware limited warranty for the power supply on the date of purchase. Please keep your receipt in a safe place.
This product is designed for computer usage only, using this device in any other application will void the warranty, if you are not familiar with computer hardware installation, please seek professional assistance.
This warranty only applies to damages caused through normal use and is void if it is determined that the device was damaged because of abuse, alteration, misuse, negligence, incorrect voltage supply, air/water pollution, accidents and natural disasters.
Troubleshooting
If your system does not turn on after installing the power supply, follow the troubleshooting guide as listed below:
- Please make sure the main power is connected on correctly.
- Please make sure the P1 and P2 connectors are connected correctly to the motherboard.
- If the power supply does not work properly, please contact the dealer from whom you purchased the product.
Disclaimer
Every effort has been made to ensure the information contained within this user manual is both accurate and up-to-date. However, we can accept no responsibility for any loss, damage or expense resulting from errors or omitted information. All content and specifications are subject to change without prior notice.