SANUS BMF522-B1 Shift TV Wall Mount Instruction Manual
- June 20, 2024
- SANUS
Table of Contents
SANUS BMF522-B1 Shift TV Wall Mount Instruction Manual
Product Information:
Specifications:
- TV Interface: 15.7in (400mm) MAX, 3.9in (100mm) MIN, 7.9in (200mm) MIN, 15.7in (400mm) MAX
- Wall Plate: 2.0in (52mm), 12.3in (312mm), 10.6in (270mm)
- Fully Assembled Mount: Height 3.0in (adjust 77mm up), Height 3.1in (adjust 78mm down), 17.3in (439mm), 17.2in (436mm), 17.6in (447mm)
- Top View – Extended: 3-D, 59deg, 59deg
- Side View – Extended: 5deg Simulated 55 Flat Screen TV
- Top View – Retracted: 5deg, 22.3in (567mm)
- Side View – Retracted: 1.9in (49mm)
IMPORTANT SAFETY INSTRUCTIONS
- PLEASE READ MANUAL PRIOR TO USE
- SAVE THESE INSTRUCTIONS
Please read through these instructions completely to be sure you’re
comfortable with this easy install process.
Check your TV owner’s manual to see if there are any special requirements for
mounting your TV. If you do not understand these instructions or have doubts
about the safety of the installation, assembly or use of this product, contact
Customer Service: +1 800-359-5520.
CAUTION: Avoid potential personal injuries and property damage!
- This product is designed ONLY to be installed into wood studs, solid concrete or concrete block
- DO NOT INSTALL INTO DRYWALL ALONE
- DRYWALL ALONE WILL NOT HOLD THE WEIGHT OF YOUR TV
- This product is designed for INDOOR USE ONLY
- The wall must be capable of supporting five times the weight of the TV and mount combined
- Do not use this product for any purpose not explicitly specified by the manufacturer
- Manufacturer is not responsible for damage or injury caused by incorrect assembly or use
TV Weight Limit
(including accessories) DO NOT EXCEED
If your TV (plus accessories) weighs MORE, this mount is NOT compatible. Visit
SANUS.com or call customer service to find a compatible
mount. +1 800-359-5520
Wall Construction
ONLY install on these acceptable wall types.
Tools Needed Dimensions
Product Usage Instructions:
Before You Begin:
- Remove the stand from your TV if attached.
- Install any accessories you may have purchased that require TV removal prior to assembly.
- Protect the face of your TV when laying it down for installation on a soft clean surface.
Supplied Parts and Hardware
WARNING : This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts!
NOTE: Not all hardware included will be used.
Tools Needed:
- Tape
- Pencil
- Level
- Measure Tape
- Screwdriver
- Electric Drill
- 1/2 in. (13 mm) Socket Wrench
- Stud Finder
- Awl
- 7/32 in. (5.5 mm) Wood Drill Bit
- 3/8 in. (10 mm) Concrete Drill Bit
- Hammer
Product Installation:
-
Step 1 : [Description of Step 1] Attach TV Bracket to TV
-
Select TV Screw Diameter
-
Select TV Screw Length and Spacers
-
NO SPACER
- Flat Back TV
[TV brackets lay flat on your TV]
- Flat Back TV
-
SPACER NEEDED
-
Flat Back TV with extra space needed
[for deep inset holes or cable interference] -
Rounded or Irregular Back TV
[TV brackets NOT resting flat on your TV]
CAUTION: Verify adequate thread engagement with your screw, washer, spacer combination AND TV bracket. -
Too short will not hold your TV.
-
Too long will damage your TV.
-
-
Attach TV Brackets to Your TV
-
NOTE: The hanging tab is oriented to the TOP of your TV.
CAUTION: Avoid potential personal injuries and property damage! DO NOT
use power tools for this step. Tighten the screws and only enough to secure
the TV brackets to the TV.
STEP 2A Attach Wall Plate
Wood Stud Installation
CAUTION:
- Avoid potential personal injury or property damage!
- Drywall covering the wall must not exceed 5/8 in. (16 mm)
- Minimum wood stud size: nominal 2 x 4 in. (51 x 102 mm) actual 1½ x 3½ in. (38 x 89 mm)
- Stud center must be verified
CAUTION: Avoid potential personal injury or property damage! Improper use could reduce the holding power of the lag screw. Tighten the lag screws only until they are pulled FIRMLY against the wall plate. DO NOT over-tighten the lag screws. Go to STEP 3 on PAGE 10.
STEP 2B Attach Wall Plate
Solid Concrete or Concrete Block Installation
CAUTION: Avoid potential personal injury or property damage!
- Mount wall plate directly onto concrete surface (no wall covering)
- Minimum solid concrete thickness: 8 in. (203 mm)
- Minimum concrete block size: 8 x 8 x 16 in. (203 x 203 x 406 mm)
CAUTION: Avoid potential personal injury or property damage! Improper use could reduce the holding power of the lag screw. Tighten the lag screws only until they are pulled FIRMLY against the wall plate. DO NOT over-tighten the lag screws.
STEP 3 Hang TV onto Wall Plate
Manage Cables
IMPORTANT: Fully extend the arm assembly to ensure enough slack in cables.
- Slide to remove the cable covers.
- Route your cables through the arm assembly.
- Reattach the cable covers over the cables.
TV Adjustments
Your TV should adjust easily when moved, and then stay in place. If your TV is
too loose or too tight, adjust the side tension knob by hand or use hex key
for additional tightening. NOTE: Once your TV is in place, tighten the tension
knob to prevent unwanted movement. NOTE: Additional tension can be applied
using a hex key
LEVEL ADJUSTMENT
CAUTION: The screw MUST be loosened before turning the screw.
HEIGHT ADJUSTMENT
REMOVING THE TV
HEAVY! You may need assistance with this step.
Frequently Asked Questions (FAQ):
Q: What is the weight limit for the TV on this mount?
A: The weight limit is 70 lb (31.7 kg), including accessories. Do not exceed
this weight limit.
Q: Can this mount be installed on drywall alone?
A: No, the product is designed only to be installed into wood studs, solid
concrete, or concrete block. Drywall alone will not hold the weight of your
TV.
WE’RE HERE TO HELP
- Want to watch a video that shows how easy this is?
- Get it right the first time. HeightFinder™ shows you where to drill.
- Our live US-based install experts are standing by to help.
Watch it now at: SANUS.com/3167
Use it now:SANUS.com/1172
Call us at: +1 800-359-5520
Or, chat at: SANUS.com/chatSP
Email us: info@sanus.com
Leave a review: SANUS.com
Legrand AV Inc. and its affiliated corporations and subsidiaries (collectively, “Legrand”), intend to make this manual accurate and complete. However, Legrand makes no claim that the information contained herein covers all details, conditions, or variations. Nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. Legrand makes no representation of warranty, expressed or implied, regarding the information contained herein. Legrand assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document. ©2024 Legrand AV Inc. All rights reserved. SANUS Elite is a brand of Legrand. SANUS Elite, HeightFinder and the Elite logo are trademarks of Legrand.