IKEA SILVERGLANS Smart Lighting Driver Instruction Manual

IKEA SILVERGLANS Smart Lighting Driver

HOW TO STEER YOUR LIGHTING

When the driver is connected to the mains, it is possible to turn ON/OFF all products connected to the driver, but if you want to dim or connect your products to IKEA Smart lighting products, you need to buy a separate steering device (e.g. a remote control).  The steering device needs to be paired with your driver/s. If you have more than one (1) driver you can pair each one with the steering device, so that the entire combination can be turned ON/OFF or dimmed at the same time.

PAIRING A STEERING DEVICE TO YOUR DRIVER

1. Connect at least one (1) product to the driver before you begin the pairing. Make sure that the mains power is turned ON.
2. Locate the pairing symbol on the driver. Hold the steering device close to the pairing symbol (no more than 5 cm away).
3. Press and hold the pairing button on the steering device for at least 10 seconds. A red light will shine steadily on the steering device. The product connected to the driver will begin to dim and flash one time to indicate that the driver is being paired to the steering device.

HOW TO FACTORY RESET YOUR DRIVER

If the driver does not respond or if you want to un-pair the driver from a steering device you might have to make a factory reset. The driver is forced to factory reset by carefully pushing and holding the small button (marked RESET) with the tip of pen on the driver enclosure and applying a slight pressure. A  factory reset can also be done by toggling the main switch 6 times.

IMPORTANT!

• The driver is for indoor use only and can be used in temperatures ranging from 5ºC to 45 ºC.
• Do not leave the driver in direct sunlight or near any heat source, as it may overheat.
• The declared radio range between the driver and the steering device is measured in open air. Different building materials and placement of the units can affect the wireless connectivity range.

CARE INSTRUCTIONS

To clean the driver, wipe with a dry soft cloth. Never use abrasive cleaners or chemical solvents as this can damage the product.

PRODUCT SERVICING

Do not attempt to repair this product yourself, as opening or removing covers may expose you to dangerous voltage points or other risks.

Technical data

• Type : ICPSHC24-30-IL44-1
• Input : 220-240 VAC, 50/60 Hz, 0.23A
• Output : 24.0V DC
• Max total load: 1.25 A, 30.0 W
• Radio range : 10 m in open air.
• Operating frequency: 2400-2483.5 MHz
• Output power: 14 dBm
• DImension, mm : 220x65x26 mm
• Weight: 233 gr
• Type of light source(s ): LED
• Efficiency in full-load : 88 %
• No-load power consumption (Pno): 0.24 W

Networked standby power

• consumption (Pnet): 0.23 W
• Standby power consumption (Psb): N/A
• Suitable as a dimmer for light sources: Yes

Indoor use only

• Manufacturer : IKEA of Sweden AB
• ( commercial registration number : 556074-7551)
• Address: Box 702, SE-343 81 Älmhult, SWEDEN

The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling under local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or landfills and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.

• Inter IKEA Systems B.V. 2020
• AA-2253403-3

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>