Shenzhen Fugetek Technologies FT-569 Selfie Stick and Tripod Bluetooth Remote Instruction Manual
- June 5, 2024
- Shenzhen Fugetek Technologies
Table of Contents
Shenzhen Fugetek Technologies FT-569 Selfie Stick and Tripod Bluetooth
Remote
FCC compliance statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation. changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will
not occur in a particular installation.lf this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:– Reorient or relocate
the receiving antenna.– Increase the separation between the equipment and
receiver.– Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.– Consult the dealer or an experienced
radio/TV technician for help.
- Product Name: Selfie Stick& Tripod Bluetooth Remote
- Model: FT-569
- Power Supply: Replaceable Battery; Lithium battery Cr2032 H3V 240mAh
- WARNING: THIS PRODUCT CONTAINS A BUTTON/COIN CELL BATTERY
4 Simple Steps to Set Up Bluetooth Remote
-
Turn the remote ON/OFF, and hold the shutter button down for 3 seconds.
Note : Please remove the battery insulating film on the back of the Bluetooth remote. -
Make sure your device’s Bluetooth is ON.
GO to your device settings > Bluetooth > Turn Bluetooth ON. -
To pair the remote to your Bluetooth device.
Fugetek will pop up under your Bluetooth devices, then select Fugetek and wait for it to connect -
When the Bluetooth device shows connected, you can now press the remote button to take photos.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>