Infinix X6528 HOT 40i Smartphone User Manual

June 12, 2024
Infinix

Infinix X6528 HOT 40i Smartphone

FAQ

Frequently Asked Questions

  • Q: Can I use any charger to charge the phone?
    • A: No, only use Infinix chargers and cables to avoid damaging the device and invalidating the warranty.
  • Q: What is the SAR value of this phone?
    • A: The SAR information indicates that this mobile phone meets government requirements for exposure to radio waves.

Explosion diagram specification

Infinix-X6528-HOT-40i-Smartphone-fig-1

1 TP+LCM 2 REC DECO
3 FRONT COVER 4 MAIN BOARD
5 SIDEKEY FPC MYLAR 6 SIDEKEY FPC
7 FRONT CAMERA 8 FINGERPRINT FPC
9 REAR CAMERA 50M 10 REAR CAMERA AI
11 REC CON FB 12 SIM CARD HOLDER
13 PS RUBBER 14 BATTERY
15 RECEIVER 16 LED FLASH
17 RF LINE 18 MID FRAME
19 SCREW M1.4L3.5D2.5 20 BATTERY COVER
21 RCAM DECO 22 RCAM DECO LENS
23 RCAM LENS 50M 24 RCAM LENS AI
25 REAR FLASH LENS 26 SCREW M1.4L3.0D2.5
27 USB RUBBER 28 EARJACK RUBBER
29 MAIN BOARD COPPER D 30 MAIN BOARD COPPER B
31 MAIN BOARD COPPER A 32 SPEAKER
33 MOTOR 34 SUB BOARD
35 SCREW M1.4L2.0D2.5  

Know your phone

Infinix-X6528-HOT-40i-Smartphone-fig-2

  1. Front camera
  2. Volume + button
  3. Volume – button
  4. Power button & side fingerprint sensor

SIM/SD card installation

Infinix-X6528-HOT-40i-Smartphone-fig-3

  1. Power off your phone.
  2. Refer to the following picture for SIM / SD card installation.

Charging the phone

Infinix-X6528-HOT-40i-Smartphone-fig-4

  • You can charge your phone with a charger or by connecting it to a computer using a USB cable (comes with the phone).
  • Use Infinix chargers and cables only. Other chargers or cables may damage the device. This will invalidate your phone warranty.

FCC STATEMENT

Labelling requirements

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference.
  2. This device must accept any interference received, including interference that may cause undesired operation.

Information to user

  • Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Information to the user

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Specific Absorption Rate (SAR) information:

This mobile phone meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.

FCC RF Exposure Information and Statement

The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: X6528(FCC ID:2AIZN-YYS-X6528) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 1.20W/kg and when properly worn on the body is 0.89 W/kg.

Body-worn Operation

This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 1.0 cm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.

For DTS patents, see http://patents.dts.com. Manufactured under license from DTS Licensing Limited. DTS, the Symbol, & DTS and the Symbol together are registered trademarks or trademarks of DTS, Inc. in the United States and/or other countries.
© DTS, Inc. All Rights Reserved.

Operating System: AndroidTM Android is a trademark of Google LLC.

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Infinix User Manuals

Related Manuals