Shark Rocket DuoClean Stick Vacuum Instruction Manual

: June 8, 2024
: Shark

Table of Contents

Shark Rocket
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Shark Rocket

DuoClean ® with Self-Cleaning Brushroll Corded Stick Vac

QUICK START GUIDE

WHAT’S INSIDE

ASSEMBLY

VERSATILE FLOOR-TO-CEILING CLEANING

Settings

Off

Slide switch to the bottom to turn off power. To begin vacuuming, slide switch to the appropriate setting.

Setting 1

Bare Floor/Small Area Rugs

The brushrolls spin slowly to clean bare floors and delicate area rugs.

Setting 2

Carpet

The brushrolls spin faster to pick up debris below the surface of your carpets.

NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please use Setting II, Carpet.

NOTE: Select Carpet for stuck-on dust and debris.

Upright Mode

Upright Mode

To clean floors, place foot on floor nozzle and tilt handheld vacuum back.

Above-Floor with Wand

with Wand

Stand the vacuum upright. Step on the foot pedal on the floor nozzle and pull the wand up to disconnect it. Great for cleaning baseboards, ceiling fans, window sills, etc.

with Handheld

Press the WAND RELEASE button and lift the handheld vacuum off the wand. Great for cleaning stairs and furniture.

NOTE: All accessories are compatible with both the wand and the handheld vacuum. Use Setting I for all above-floor accessories.

STORAGE

Onboard Hook

Onboard Hook

Hang the handheld vacuum on the hook on the bottom of the wand, and wrap the power cord around the cord hooks.

NOTE: Wrap the power cord around the top hook first, leaving a little slack.

DUST CUP

Empty dust cup every time debris reaches the MAX fill line.

DUST CUP A

To remove the dust cup from the handheld vacuum, squeeze the two Dust Cup Release buttons at the same time and pull out the dust cup. Holding the dust cup over a trash bin, press the Empty button on the front of the dust cup.

DUST CUP B

With the dust cup attached to the handheld vacuum, hold the dust cup over a trash bin and press the Empty button on the front of the dust cup.

MAINTENANCE

Brushroll/Soft Roller Access

To open the brushroll garage, slide both release buttons on the floor nozzle away from you, toward the back of the nozzle, then lift off the lid.
To close the brushroll garage, insert the 3 tabs on top of lid into the 3 slots in the nozzle, then push down on both sides of lid until it clicks securely into place. If Brushroll Indicator Light is green and headlights are flashing, check again that both sides of lid are locked in place.

Soft Roller Access

Brushroll Maintenance

With the garage lid removed, carefully clear away any debris that may be impeding the brushroll.

Brushroll Maintenance

NOTE: If you see any hair wrapped around the brushroll, continue cleaning, using Setting II, Carpet, on bare floors. This will allow the self- cleaning brushroll to remove the hair wrap and send it to the dust cup.

Cleaning the Soft Roller

Open the brushroll garage. Lift out the Soft Roller by pulling the tab on the right side. Clear away any debris, then slide the Soft Roller back into place.

Cleaning the Soft Roller