GNB LAB AX-700 Lovewax Wax Warmer Instruction Manual
- June 3, 2024
- GNB LAB
Table of Contents
GNB LAB AX-700 Lovewax Wax Warmer
The warmer is ideal for all types of depilatory waxes. It melts any type of wax, including canned waxes, wax drops or black wax.
- MODEL: AX-700
- Certificate no: POCE19032609NCS, POCE19032614SCE.
Technical parameters
- Power: 120W
- Power supply: 120W
- Input voltage: 220/230V
- output voltage: 220/230V
- Capacity 500ml
- Temperature range: 0-120°C
- Aluminium inner container
Preparing the device for operation
-
Connect the appliance to the power supply.
-
Remove the plastic lid from the warmer. Place canned wax or wax drops in the warmer.
-
Switch on the heater, set the temperature unit (°C or °F) and set the temperature until the wax melts. This process takes about 15 min, to speed it up, put a lid on the
warmer. The higher the temperature of the wax, the faster it will melt. -
Once the wax has melted, reduce the temperature to a lower temperature, such that it does not burn the skin. It is important to check the temperature of the wax
before applying it, adjusting the temperature if necessary. The wax must not be too hot or too cold. -
Proceed with the treatment.
-
When the treatment is complete, remove the wax can from the device, switch off the device and then cover it with the lid.
-
Clean the device after switching it off from the power supply, with a special agent, when it is slightly warm.
Precautions
- Ensure that the user does not have any skin diseases before performing the treatment.
- Do not directly touch the heating elements or the aluminium container.
- Do not heat the empty aluminium container.
- The appliance must be connected to a power supply conforming to the appliance specifications.
- Do not unplug the appliance from the mains whilst it is switched on and in operation.
- Stop using the appliance if you notice any unusual movement or noise.
- Store and use in dry areas. Keep away from water, moisture. Otherwise the device may stop working and/or become damaged.
- Unplug the appliance from the mains supply when you have finished using it.
- If the mains cable is damaged, replace it with a new one of the same type at a service centre.
- It is forbidden to make any unauthorised changes or modifications to the appliance.
- Opening the appliance is categorically forbidden and equivalent to the loss of the guarantee, and the manufacturer is not responsible for the correct and safe operation of the appliance.
IMPORTER
GNBLab
Michał Szewczyk, Piotr Malinowski s.c.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>