GNB LAB AX-300 Lovewax Wax Warmer User Manual
- June 3, 2024
- GNB LAB
Table of Contents
GNB LAB AX-300 Lovewax Wax Warmer
The heater is ideal for all types of depilatory waxes. Dissolves any type of wax, including canned waxes, wax drops or black wax.
- MODEL: AX-300
TECHNICAL SPECIFICATION
- Power: 200W
- Power supply: 100W
- input voltage: 220/230V
- output voltage: 220/230V
- Capacity 500ml
- Temperature range: 0-120°C
- Aluminium inner container
Preparing the device for operation
- Connect the appliance to the power supply.
- Remove the plastic lid from the warmer. Place canned wax or wax drops in the warmer.
- Switch on the warmer, set the temperature setting knob to MAX until the wax has melted. This process takes about 15 min, to speed it up, put the lid on the warmer. The higher the temperature of the wax, the faster it will melt.
- Once the wax has melted, reduce the temperature on the MED and, if necessary, adjust the temperature so that it does not burn the skin. It is important to check the temperature of the wax before applying it, adjusting the temperature if necessary. The wax must not be too hot or too cold.
- Proceed to treatment.
- When the treatment is complete, remove the wax can from the unit, switch off the unit and then cover it with the lid.
- The appliance can be cleaned after being switched off from the power supply, using a special agent, when it is slightly warm.
Precautions
- Ensure that the user does not have any skin diseases before performing the treatment.
- Do not directly touch the heating elements or the aluminium container.
- Do not heat an empty aluminium container.
- Connect the device to a network that complies with the device specifications.
- Do not unplug the unit from the mains when the unit is switched on and running.
- Stop using the appliance if you notice any unusual movement or noise.
- Store and use in dry areas. Keep away from water, moisture. Otherwise the device may stop working and/or be damaged.
- When you have finished using the device, unplug it from the mains supply.
- If the supply cable is damaged, it must be replaced with a new one of the same type at a service centre..
- It is forbidden to make any unauthorised changes to the device..
- Opening the device is categorically prohibited and will void the warranty and the manufacturer assumes no responsibility for the correct and safe operation of the device.
- Keep away from children.
IMPORTER
GNBLab
Michał Szewczyk, Piotr Malinowski s.c.
References
Read User Manual Online (PDF format)
Loading......