Bissell Steam 94E Series MOP Select Vacuum User’s Guide

Bissell® STEAMmop™ Select

USER’S GUIDE
94E9 SERIES

Important Safety Instructions

When using an electrical appliance, basic precautions should be observed, including the following:

Read all instructions before using your Steam Mop™ Select.

WARNING: To reduce the risk of fire, electric shock, or injury:

• Do not direct steam at people, animals, or at electrical outlets.
• Do not expose to rain.
• Store indoors.
• Unplug from outlet when not in use and before conducting maintenance or troubleshooting.
• Do not leave steam cleaner unattended.
• Do not expose hair, loose clothing, fingers or body parts to openings or moving parts.
• Do not service steam cleaner when it is plugged in.
• Do not handle steam cleaner with wet hands.
• Do not use steam cleaner if it has been dropped, damaged, left outdoors or dropped into water, return it to a service center.
• Do not pull or carry by cord, use cord as a handle, close door on cord, pull cord around sharp corners or edges, or expose cord to heated surfaces.
• Do not unplug by pulling on cord.
• Do not use appliance in an enclosed space filled with vapor given off by oil-base paint, paint thinner, some moth proofing substances, flammable dust, or other explosive or toxic vapors.
• Do not allow to be used as a toy.
• Do not use on leather, wax polished furniture or floors, synthetic fabrics, velvet or other delicate, steam-sensitive materials.
• Do not immerse.
• Do not use for any purpose other than described in this User’s Guide.
• Use only manufacturer’s recommended attachments – use of attachments not provided or sold by BISSELL may cause fire, electric shock or injury.
• Never put descaling, aromatic, alcoholic or detergent products into the steam cleaner, as this may damage it or make it unsafe for use.
• Unplug by grasping the plug, not the cord.
• Close attention is necessary when used by or near children.

SAVE THESE INSTRUCTIONS

Commercial use of this unit void the manufacturer’s warranty.

THIS APPLIANCE HAS A POLARIZED PLUG.

To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider then the other) This plug will fit in a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a proper outlet. Do not change the plug in any way.

This model is for household use only.

Product view

Optional Accessories:

Assembly

Your Steam Mop Select assembles quickly and easily. Your Steam Mop Select is packaged with the following items:

Handle Assembly

Lower Body

Maneuverable Mop Head

Removable Water Tank

2 Steam Mop Select Mop Pads

1. Attach lower body to mop head by snapping it into place.
2. Slide handle assembly down into lower body until it snaps into place.
3. Slide water tank onto lower body and gently push tank into place.

Steam Mop Select assembly is now complete.

Special features

Removable water tank

The water tank is located on the top of the Steam Mop Select. It can be refilled with water any time during use. Distilled or demineralized water is recommended in place of tap water.

Do not use chemicals with your Steam Mop Select.

Indicator light

The indicator light will glow when the Steam Mop Select is plugged in.

Steam on demand trigger

Press to release steam.

Microfiber Mop Pads

Reusable microfiber mop pad is machine washable and safe for all hard floor surfaces. Your Steam Mop Select may have come with two different pads. The all-white “soft” pad is best for everyday use on delicate flooring like sealed hardwoods and laminate. The gray and white striped pad can be used for scrubbing heavily soiled floors and tougher messes.

Tip:
Do not attempt to use your Steam Mop Select without water in the tank.

Operations

Getting ready

The mop pad may have already come attached to the mop head, if not follow steps 1A and 1B below.

1. Attach mop pad
   A. Set mop head in mop pad, making sure toggle is located on the back.
   B. Tighten mop pad by pulling on elastic cord while pressing on toggle.

2. Fill the water tank
   A. Remove tank by lifting straight up and away from unit.
   B. Unscrew cap at bottom of water tank.
   C. Fill water tank with water. For best results, water should be at room temperature.
   D. Replace the cap, tighten until snug.
   E. Replace water tank by gently sliding tank into place.

3. Twist the quick release cord wrap clockwise to unwrap the power cord completely and plug into a 120-Volt outlet as described on the Important Safety Instructions, page 3.

4. The indicator light will illuminate when the Steam Mop Select is plugged in.
   NOTE: Upon first use of the Steam Mop Select or first use after refilling the water tank, the pump may make a “knocking” sound. This is normal and should only last a few seconds. While in use, the pump will continue to make a soft “knocking” sound. This is also normal.

Tip:
Use of distilled water is recommended to prolong the life of your Steam Mop Select

Before you clean

Thoroughly sweep or vacuum floor prior to cleaning with the Steam Mop Select.

Warning:

Never put descaling, alcoholic, or detergent products into the steam cleaner, as this may damage it or make it unsafe for use. Only use BISSELL authorized aromatic products

Cleaning hard floors

Your Steam Mop Select is designed to clean hard flooring such as ceramic tile, vinyl, laminate, marble, stone and sealed hard wood floors. Use of your Steam Mop Select on waxed or some unwaxed floors may result in a diminished glossiness. The Steam Mop Select is not for use on unsealed wood floors. For best results test in an inconspicuous area and check the care instructions from your flooring manufacturer.

1. Plug the unit in and wait 30 seconds for it to heat up. Begin cleaning by slowly passing over surface while pressing the steam on demand trigger to emit steam as needed.
2. To sanitize an area of your floor, (attack invisible germs and bacteria) place the Steam Mop Select over the spot for a minimum 15 seconds using continuous steam, but no longer than 20 seconds using continuous steam. For larger areas, overlap swivel head placement.
3. When the Steam Mop Select stops emitting steam, unplug the unit. Simply remove the water tank, refill, and continue cleaning.

Maintenance and care

CAUTION:

Upright storage of the Steam Mop Select with a wet mop pad may result in the formation of white marks on your floor. To remove the white marks, clean area with vinegar.

When you’re done

1. Unplug power cord from outlet.
2. Carefully remove mop pad from flip head, as mop pad and lower assembly may be hot.
3. Any water remaining in the water tank should be emptied prior to machine storage.
4. Mop pad can be machine washed in warm water. Use only liquid detergents. Do not use fabric softeners. For best results, air dry.
5. Wrap power cord around quick release cord wrap on side of Steam Mop Select.
6. Wipe all surfaces of Steam Mop Select with a soft cloth. Store upright in a protected, dry area.

Troubleshooting

Reduced steam or no steam.

Possible Causes

1. Water tank empty

Remedies

1. Fill tank

Other maintenance or service not included in the manual should be performed by an authorized service representative.

Thank you for selecting a BISSELL product.

Please do not return this product to the store.

For any questions or concerns, BISSELL is happy to be of service. Contact us directly at 1-800-237-7691.

Replacement parts- BISSELL Steam Mop™ Select

Additional Accessories

Bissell Steam 94E Series MOP Select Vacuum User’s Guide – Download [optimized]
Bissell Steam 94E Series MOP Select Vacuum User’s Guide – Download

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>