Bissell 47R5 Series Cleanview Deluxe Corded Hand Vacuum User’s Guide

June 8, 2024
Bissell

Cleanview® Deluxe Corded Hand Vacuum User’s Guide

47R5 Series

47R5 Series

Important Safety Instructions

When using an electrical appliance, basic precautions should be observed, including the following:

Read all instructions before using your HAND VACUUM.

Always connect to a polarized outlet (left slot is wider than right). Unplug from outlet when not in use and before conducting maintenance.

WARNING: To reduce the risk of fire, electric shock, or injury:

  • Do not modify the polarized plug to fit a non-polarized outlet or extension cord.
  • Do not leave hand vacuum cleaner unattended when it is plugged in.
  • Unplug from outlet when not in use and before servicing.
  • Unplug before attaching the nozzles.
  • Do not use outdoors or on wet surfaces.
  • Do not allow children to operate vacuum cleaner or use as a toy.
  • Close attention is necessary when used by or near children.
  • Do not use for any purpose other than described in this user’s guide.
  • Use only manufacturer’s recommended attachments.
  • Do not use with damaged cord or plug.
  • If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, have it repaired at an authorized service center.
  • Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
  • Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
  • Do not handle hand vacuum cleaner or plug with wet hands.
  • Do not put any object into openings. Do not use with any opening blocked; keep openings free of dust, lint, hair, and anything that may reduce air flow.
  • Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
  • Turn off all controls before plugging or unplugging vacuum cleaner.
  • Use extra care when cleaning stairs.
  • Do not pick up flammable materials (lighter fluid, gasoline, kerosene, etc.) or use in the presence of explosive liquids or vapors.
  • Do not pick up toxic material (chlorine bleach, ammonia, drain cleaner, etc.).
  • Do not use hand vacuum cleaner in an enclosed space filled with vapors given off by oil base paint, paint thinner, some moth proofing substances, flammable dust, or other explosive or toxic vapors.
  • Do not pick up hard or sharp objects such as glass, nails, screws, coins, etc.
  • Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
  • Do not use without filters in place.
  • Use only on dry, indoor surfaces.
  • Keep appliance on a level surface.

SAVE THESE INSTRUCTIONS FOR FUTURE USE

THIS APPLIANCE HAS A POLARIZED PLUG.

To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a proper outlet. Do not change the plug in any way.

This model is for household use only.

Product view

Product view

Operations

Power switch

The power switch is located on the end of the curved handle.

To turn hand vacuum ON ( I ), press up.

To turn hand vacuum OFF ( 0 ), press down.

Cleaning with flexible rubber contour nozzle

The CleanView Deluxe comes with the rubber contour nozzle already attached. This attachment is great for vacuuming up pet hair, stair cleaning, upholstery, and many other uses.

Cleaning with hose attachment and tools

  1. Turn hand vacuum OFF (O).
  2. Remove flexible rubber nozzle by pressing down on round nozzle release button.
  3. Replace with hose adapter nozzle by lining up the bottom of nozzle to the bottom of the dirt container. Pivot upwards to snap into place.
  4. Make sure the nozzle has snapped securely into place before using.
  5. Attach the flexible hose to the hose adapter nozzle. Choose the tool appropriate for your cleaning job and attach to the end of the hose.

ATTENTION: For best performance, dirt container and filter assembly should be cleaned after every use.

Emptying the dirt container

Empty the dirt container after each use. A full dirt container may reduce suction or performance of vacuum.

  1. Emptying the dirt container Turn hand vacuum OFF (O).

  2. Unplug hand vacuum from electrical outlet.

  3. Press dirt container release latch down to disconnect dirt container and filter assembly from the unit.

  4. Remove filter by grasping tabs on both sides of filter frame and pulling away from the dirt container. For best results, periodically tap filter assembly against trash can to remove dirt that has collected on the screen and filter.

  5. Empty dirt into trash can.

  6. Replace filter assembly by aligning side labeled “TOP” into top of dirt container. Grasp filter tabs and press firmly to ensure filter assembly is secure in dirt container.
    NOTE: Make sure side of filter assembly labeled “TOP” faces outward when inserting filter assembly into dirt container.

  7. Reattach dirt container to unit by aligning bottom of dirt container to bottom of unit. Pivot upwards and snap into place. Use one hand to hold the unit and use the other hand to clip the dirt container securely in place.

Maintenance and care

Cleaning the filter and screen

  1. Cleaning the filter and screen Turn hand vacuum OFF (O).
  2. Unplug hand vacuum from electrical outlet.
  3. Press dirt container release latch down to disconnect dirt container and filter assembly from the unit.
  4. Remove filter by grasping tabs on both sides of filter frame and pulling away from the dirt container.
  5. Separate filter assembly by grasping tabs on both sides of assembly and pull. For best results, periodically tap filter and screen against trash can to remove dirt that has collected on the screen and filter.
  6. Reconnect filter and screen by aligning rectangular tab on filter with insert on screen. Press together to ensure assembly is secure.
  7. See page 5 to reattach dirt container.
    NOTE: Dirt container and screen may be rinsed with cold water. Ensure both are dry before reinserting. Do not wash or rinse pleated filter.

Storage/Cord wrap system

A wrap is always attached to the cord for quick and easy storage.

  1. To store the unit, turn hand vacuum OFF (O).
  2. Unplug hand vacuum from electrical outlet.
  3. Bundle cord, using wrap that is located on cord, to store.

WARNING: To reduce the risk of electric shock, turn power OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting.

Troubleshooting

Hand vacuum won’t turn on

Possible causes

  1. Power cord not plugged in
  2. Blown fuse/tripped breaker in home

Remedies

  1. Check electrical plug
  2. Check/replace fuse or reset breaker

Hand Vacuum won’t pick up or low suction

Possible causes

  1. Dirt container not installed properly
  2. Dirt container is full
  3. Filter or screen is dirty
  4. Nozzle or hose is clogged with debris

Remedies

  1. Check assembly of dirt container making sure it is securely in place
  2. Empty dirt container and reattach
  3. See instructions above. Replace filter if needed
  4. Remove hose and tool and remove debris

Other maintenance or service not included in the manual should be performed by an authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
For any questions or concerns, please contact BISSELL Consumer Care at 1-800-237-7691.

BISSELL Consumer Care

For information about repairs or replacement parts, or questions about your warranty, call:

BISSELL Consumer Care
1-800-237-7691

Monday – Friday 8 a.m. — 10 p.m. ET
Saturday 9 a.m. — 8 p.m. ET

Or write:
BISSELL Homecare, Inc.
PO Box 3606
Grand Rapids MI 49501
ATTN: Consumer Care

Or visit the BISSELL website – www.bissell.com

When contacting BISSELL, have model number of cleaner available.
Please record your Model Number: ___
Please record your Purchase Date: ____

NOTE: Please keep your original sales receipt. It provides proof of purchase date in the event of a warranty claim. See Warranty on page 8 for details.

Replacement parts – BISSELL vacuum

Item Part No. Part Name
1 97D5 Pre-Motor Filter Assembly
2 203-1454 Flexible Rubber Contour Nozzle
3 203-1458 Flex Hose
4 203-1456 Crevice Tool
5 203-1455 Wide Mouth Tool
6 203-1457 Hose Adapter Nozzle

Replacement parts

Bissell 47R5 Series Cleanview Deluxe Corded Hand Vacuum User’s Guide – Download [optimized]
Bissell 47R5 Series Cleanview Deluxe Corded Hand Vacuum User’s Guide – Download

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals