Bissell 1330, 1331, 1334 Series Cleanview Vacuum User Guide
- June 8, 2024
- Bissell
Table of Contents
CLEANVIEW ® Vacuum USER GUIDE 1330, 1331, 1334 SERIES
More of a video person? Look for this icon and go online for an instructional how-to video at www.BISSELL.com
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING YOUR UPRIGHT VACUUM.
Always connect to a polarized outlet (one slot is wider than the other).
Unplug from outlet when not in use and before conducting maintenance. When
using an electrical appliance, basic precautions should be observed, including
the following:
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY:
» Always connect to a polarized outlet (one slot is wider than the other).
Do not modify the polarized plug to fit a non-polarized outlet or extension
cord.
» Do not leave vacuum cleaner when it is plugged in. Unplug from outlet when
not in use and before servicing.
» Do not use outdoors or on wet surfaces.
» Do not allow to be used as a toy. Close attention is necessary when used by
or near children.
» Do not use for any purpose other than described in this User’s Guide. Use
only the manufacturer’s recommended attachments.
» Do not use with damaged cord or plug. If appliance is not working as it
should, has been dropped, damaged, left outdoors, or dropped into water, have
it repaired at an authorized service center.
» Do not pull or carry by cord, use cord as a handle, close a door on cord, or
pull cord around sharp edges or corners. Do not run appliance over cord. Keep
the cord away from heated surfaces.
» Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
» Do not handle plug or vacuum cleaner with wet hands.
» Do not put any object into openings. Do not use with any opening blocked;
keep openings free of dust, lint, hair, and anything that may reduce airflow.
» Keep hair, loose clothing, fingers, and all parts of body away from openings
and moving parts.
» Turn off all controls before plugging or unplugging vacuum cleaner.
» Use extra care when cleaning on stairs.
» Do not use to pick up flammable or combustible materials (lighter fluid,
gasoline, kerosene, etc.) or use in areas where they may be present.
» Do not use vacuum cleaner in an enclosed space filled with vapors given off
by oil base paint, paint thinner, some moth-proofing substances, flammable
dust, or other explosive or toxic vapors.
» Do not use to pick up toxic material (chlorine bleach, ammonia, drain
cleaner, etc.).
» Do not pick up anything that is burning or smoking, such as cigarettes,
matches, or hot ashes.
» Do not use without filters in place.
» Do not pick up hard or sharp objects such as glass, nails, screws, coins,
etc.
» Use only on dry, indoor surfaces.
» Keep appliance on a level surface.
» Do not carry the vacuum cleaner while it is running.
» Unplug before connecting or disconnecting the TurboBrush® Tool.
SAVE THESE INSTRUCTIONS
This model is for household use only.
WARNING ›› Before using your vacuum, make sure the dirt container is in
locked position and that all filters, both pre-and post-filters are in place.
DO NOT operate your vacuum without these filters.
›› Plastic film can be dangerous. To avoid the danger of suffocation, keep
away from children.
›› Do not plug in your vacuum UNTIL you are familiar with all instructions
and operating procedures.
›› To reduce the risk of electrical shock, turn the power switch off and
disconnect the polarized plug from the electrical outlet BEFORE performing
maintenance or troubleshooting checks.
THIS APPLIANCE HAS A POLARIZED PLUG
To reduce the risk of electric shock, this appliance has a polarized plug
(one blade is wider than the other). This plug will fit in a polarized outlet
only one way. If the plug does not fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician to install a proper
outlet. Do not change the plugin anyway.
|
Thanks for buying a BISSELL vacuum!
We love to clean and we’re excited to share one of our innovative products with you. This guide has important instructions on how your new vacuum works, including using (page 11), maintaining (pages 14-17), and if there is a problem, troubleshooting (page 18).
In just a few simple assembly steps, you’ll be ready to vacuum. Flip to page 5 and let’s get started! What’s In The Box?
Product View
WARNING the warning does not plug in your vacuum until you are familiar with all instructions and operating procedures.
NOTE : The Crevice Tool is stored inside the Extension Wand.
Assembly
NOTE : The power foot will not suction properly unless the hose is firmly attached.
Operations: Power On & Settings
WARNING The rotating floor brush continues to rotate while tools are in use. To reduce the risk of injury from moving parts, always move the vacuum with the carrying handle at the back of the vacuum. Always place the vacuum on the floor with handle in an upright position when using tools. Never place your fingers under the vacuum when it is running. Never place powerfoot on furniture or uneven surfaces. Do not place vacuum close enough to objects to pull them into a rotating brush.
NOTE : Certain carpets and low humidity conditions may generate small static discharges. Static discharges are entirely harmless and are not associated in any way with the main power supply.
Maintenance: Clean Dirt Tank
WARNING To reduce the risk of electric shock, turn power switch off and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.
NOTE : The dirt tank may be washed in warm water with a mild detergent. Make sure it is completely dry before replacing.
Pre-Motor Filter
WARNING
|
Do not operate vacuum with damp or wet filters or without all filters in place.
---|---
Post-Motor Filter
NOTE : The pleated post-motor filter may NOT be washed with water or detergent. Replace the post-motor filter every 3 to 6 months.
NOTE : If an object becomes lodged in foot and brush shuts off, turn vacuum off and unplug from electrical outlet. Remove obstruction and brush will automatically reset when vacuum is plugged and turned back on.
TurboBrush® & TurboEraser® Tool
Troubleshooting
WARNING To reduce the risk of electric shock, turn power switch off and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks.
Problem
|
Possible causes
|
Remedies
Vacuum won’t turn on
|
Power cord not plugged in
|
Check electrical plug
Blown fuse/tripped breaker
|
Check/replace fuse or reset breaker
Vacuum won’t pick up dirt
|
Incorrect height adjustment
|
Adjust powerfoot to correct height setting
Hose not attached to suction opening
|
Grasp the hose wand and firmly push into the hose wand base
Crack or hole in hose
|
Check hose and replace if needed
Broken or worn drive belt
|
Replace drive belt, see page 9
Rotating floor brush bristles worn
|
Replace brush
Rotating floor brush jammed
|
Remove brush and clean debris from brush ends, see page 9
Clog in vacuum
|
Check for debris build-up or clogs in inner tank, where tank connects to hose, and where hose connects to base. See online video for more help.
Dirt tank full
|
Empty dirt tank
Dirt tank or upper tank not installed properly
|
Position correctly and lock in place
Filters are dirty
|
Check and clean or replace pre-motor and post-motor filters, see page 10 & 11
Tool won’t pick up
|
Crack or hole in hose
|
Check hose and replace if needed
Clog in vacuum
|
Check for debris build-up or clogs in inner tank, where tank connects to hose, and where hose connects to base. See online video for more help.
Dirt tank full
|
Empty dirt tank
Dirt tank or upper tank not installed properly
|
Position correctly and lock in place
Filters are dirty
|
Check and clean or replace pre-motor and post-motor filters, see page 8
Vacuum
difficult to push
|
Incorrect height adjustment
|
Adjust powerfoot to correct height setting
Visible dirt escaping from vacuum
|
Dirt tank full
|
Empty dirt tank
Filters missing or installed incorrectly
|
Check pre-motor and post-motor filters for correct installation
Warranty
This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Care by E-mail, telephone, or regular mail as described below.
Limited Two-Year Warranty
Subject to the *EXCEPTIONS AND EXCLUSIONS identified below, upon receipt of the product BISSELL will repair or replace (with new or remanufactured components or products), at BISSELL’s option, free of charge from the date of purchase by the original purchaser, for two years any defective or malfunctioning part.
See information below on “If your BISSELL product should require service”.
This warranty applies to products used for personal, and not commercial or rental service. This warranty does not apply to fans or routine maintenance components such as filters, belts, or brushes. Damage or malfunction caused by negligence, abuse, neglect, unauthorized repair, or any other use not in accordance with the User’s Guide is not covered.
BISSELL IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY NATURE ASSOCIATED WITH THE USE OF THIS PRODUCT. BISSELL’S LIABILITY WILL NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
*EXCEPTIONS AND EXCLUSIONS FROM THE TERMS OF THE LIMITED WARRANTY
THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES EITHER ORAL OR WRITTEN. ANY IMPLIED WARRANTIES WHICH MAY ARISE BY OPERATION OF LAW, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE TWO YEAR DURATION FROM THE DATE OF PURCHASE AS DESCRIBED ABOVE.
Some states do not allow limitations on how long an implied warranty lasts so the above limitation may not apply to you. NOTE: Please keep your original sales receipt. It provides proof of date of purchase in the event of a warranty claim.
Service
If your BISSELL product should require service:
Contact BISSELL Consumer Care to locate a BISSELL Authorized Service Center in your area. If you need information about repairs or replacement parts, or if you have questions about your warranty, contact BISSELL Consumer Care.
Website:
www.BISSELL.com
E-mail:
www.BISSELL.com/email-us
|
|
Call:
BISSELL Consumer Care
Monday – Friday 8am – 10pm ET
Saturday 9am – 8pm ET
Sunday 10am – 7pm ET
---|---|---
Please do not return this product to the store.
Other maintenance or service not included in the manual should be performed by
an authorized service representative.
For any questions or concerns, BISSELL is happy to be of service.
Contact us directly at 1-800-237-7691.
Register your product today!
Registering is quick, easy and offers you benefits over the lifetime of your
product.
You’ll receive:
BISSELL Rewards Points
Automatically earn points for discounts and free shipping on future purchases.
Faster Service
Supplying your information now saves you time should you need to contact us
with questions regarding your product.
Product Support Reminders and Alerts
We’ll contact you with any important product maintenance reminders and alerts.
Special Promotions
Optional: Register your email to receive notice of offers, contests, cleaning
tips and more!
Visit
www.BISSELL.com/registration
now!
Visit us online at BISSELL.com
When contacting BISSELL, have the model number of vacuum available.
Please record your
Model Number:
Please record your
Purchase Date:
NOTE : Please keep your original sales receipt. It provides proof of
purchase date in the event of a warranty claim. See Warranty on page 11 for
details.
We can’t wait to hear from you!
We really do read your comments, tweets, and posts.
Rate this product on BISSELL.com
Parts & Supplies For Parts and Supplies, go to BISSELL.com and enter your model number in the search field.
Bissell 1330, 1331, 1334 Series Cleanview Vacuum User Guide – Download
[optimized]
Bissell 1330, 1331, 1334 Series Cleanview Vacuum User Guide –
Download
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>