Eachine TX805S Transmitter Instruction Manual
- June 8, 2024
- Eachine
Table of Contents
Eachine TX805S Transmitter Instruction
PRODUCT SPECIFICATION
Specification and Parameters:
- Input voltage: 7V to 24V
- 5V camera supply: 220mA(MAX)—-25mW@12V(Type)
- 5V camera supply: 470mA(MAX)—-500mW@l2V(Type)
- 5V camera supply: 550mA(MAX)—-1000mW@l2V(Type)
- 5V camera supply: 830mA(MAX)—-1600mW@l2V(Type)
- Cable connector: Solder pads
- Dimensions: 36mm22mm5mm,30.5 stackable hole
- Weight: 1 l.3g (excluding antenna)
Button Control
Select channels by simple short presses.
Blue LED light on stands for CH l ,short presses to change 8 channels
sequentially.
For CH2/3/4/5/6/7 /8. Blue LED flicker once, it won’t light on. Notice: Blue
LE
Power select
Press button for 4S,Red LED will flash,then select power by simple short
presses to select 25m W /500m W /I 000m W sequentially,For 500mW, Green LED
flicker once it won’t light on;
For 1 000m W Blue LED flicker once, it won’t light on . Press the button
again, Red LED, Green LED and Blue LED lights together, Represents the highest
power 1600m W.
Notice: Red LED only light on for 25mW.
Pit Mode(0.0lmW)
While in Pit Mode you can change channels and set power levels but none of these changes will take effect until you quit Pit Mode. By default, Pit Mode will send a very weak signal.
Two ways to exit pit mode:
Press Button 12S until all 16 LED turned off and light on again to exit pit
mode, or you can exit pit mode via Betaflight OSD.
Notice: The VTX has memory for settings, To change the settings ,please
repeat steps as above.
Frequency and channel frequency table:
Eachine TX805S Transmitter Instruction Manual –
Download
Eachine TX805S Transmitter Instruction Manual – Download
[optimized]
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>