WaterLabs Filter Installation Guide
- June 7, 2024
- WaterLabs
Table of Contents
User Manual
WaterLabs Filter
Filter Installation:
- Use standard fittings while installing the filter in piping network.
- Ensure correct inlet/outlet direction.
- The direction of water flow can also be seen from arrow on the filter’s inlet/outlet arms where “screen” is mentioned above the arrow. That is the direction of flow of water. You can also understand the connections by looking at the picture below. · Never open the filter when it is under pressure.
Cleaning:
- Turn off the water supply.
- Before opening the filter, drain all water insider the strainer by opening the “drain valve cap”
- Now to open the filter, Remove the bottom housing cover (Cup-shaped bottom lid) by rotating it anticlockwise. Then remove the filter Cartridge slowly.
- Use a brush, some soap, and clean water to clean the cartridge and remove all dirt.
- After cleaning Reassemble the cartridge inside the filter body.
- Usually, it needs to be cleaned only once a month depending on the water quality it might vary
Assembly:
- Ensure the rubber ring is properly fit to the cartridge.
- Ensure the cartridge is properly aligned with top and bottom of filter so that no unfiltered water flows through the outlet.
- Turn on the water supply
- The pressure gauge connections are used to measure pressure. For Home use Leave them as it is For any further query contact our customer support through WhatsApp/call: +91-86689-92846 In the End if You like the product and our service do write a review for our product and rate us, it helps us serve more customers like you. If unhappy with the product or service do let us know and give us a chance to resolve your problem. WaterLabs is committed to sell products and services that provide high customer value and customer satisfaction. 🙂 We sincerely appreciate your efforts to review and rate our product.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>