Leaf Wireless Bluetooth Headphone User Manual
- June 7, 2024
- Leaf
Table of Contents
User Manual – Leaf Bass 2
OVERVIEW
Leather Padded Headband, Power Button/Play/Pause, Vol.
Increase/Next Song, Vol. Decrease/Previous Song, Soft Earpads, LED Indicator,
Micro USB Port, 3.5 mm Aux Port, Built-in Mic, Matte Finish, Glossy Finish
TURNING ON/OFF
Please charge your Leaf Bass 2 for 2.5 hours before turning on for enhanced battery life.
Turning ON: Press and hold the multifunction button until you hear “Power on” and you see the blue light flashing.
Turning OFF: Press and hold the multifunction button until you hear turn off sound.
BLUETOOTH PAIRING MODE
- Keep your Leaf Bass 2 within 1 meter when pairing.
- Make Leaf Bass 2 enters pairing mode as shown:
— Ensure Leaf Bass 2 is off. Press and hold the Power Button for approximately 2 seconds until Blue LED flashes rapidly.
-
In the Bluetooth settings of your mobile phone, scan/search for available bluetooth devices. Select “Leaf Bass 2” from the list of devices shown.
-
If prompted, enter password or PIN No: “0000”
-
If prompted by your mobile phone to connect, select “Yes” (This will vary among mobile
phone models). -
After connecting successfully, blue LED of headphones will stop flashing.
CHARGING
Leaf Bass 2 comes with a built-in rechargeable battery, prior to using it, It is recommended to charge the battery fully for the first time.
-
Plug in the micro USB in the charging port.
— Red Light ON : Charging
— Red Light OFF : Fully Charged -
It will take about 2.5 hours to fully charge.
ATTENTION : Do not charge products with Turbo charger, chargers with current output > 1.2 A
CONTROLS
Leaf Bass 2 comes with loaded functionalities which you can use to control music, calls and much more.
FUNCTIONS OPERATION
Volume up Short press “V+” button
Volume down Short press “V-” button
Next song Long press “V+” button
Last song Long press “V-” button
Pause Press the Play/Pause Button
Play Press the Play/Pause Button
Answer a call Press multifunction button once
Reject incoming call Long press multifunction Button for about 2
seconds
End ongoing call Press multifunction button once
USING AUX
NOTE : If your Leaf Bass 2 is fully discharged you can still use it to listen to music by plugging in Aux.
Insert one end of Aux in Leaf Bass 2’s aux port and other end in your mobile and start listening to music worry free.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>